Jensen MPX6411 Instruction Manual - Page 6
Tools and Supplies, Pre-installation - wiring
UPC - 043258302700
View all Jensen MPX6411 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
PREPARATION Tools and Supplies The following tools and supplies are needed to install the radio. • Torx type, flathead and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for power connections • 16-18 gauge speaker wire SPEAKER REQUIREMENTS: Only connect speakers rated in the load impedance of 4 ohms. Speakers with a load impedance less than 4 ohms could damage the unit. Pre-installation 1. Disconnect Battery Before you begin, always disconnect the battery negative terminal. 2. Remove Transport Screws 3. Remove Radio from Sleeve Lift latches on both sides of sleeve to remove half-sleeve from radio. TRANSPORT SCREWS HALF SLEEVE 2 MPX6411