Jensen NVXM1000 User Manual - Page 4

Warnings and Safety Information The NVXM1000 is a navigation system with integral XM® Radio that helps you find your way to your selected destination. It will determine your exact location with the help of an internal GPS device. The position information obtained from the GPS receiver will not be transmitted anywhere, so others will not be able to track you. If you are the driver of the vehicle, we recommend that you familiarize yourself with the operation of the NVXM1000 before beginning your journey. The driver's attention should be on the road. Plan your route before departure and pull over if you need to change route parameters. Navigation with XM® Ready has a built-in (optional) Safety Mode that will prevent you from using the screen functions if your car is in motion. Unless a passenger will be the only one to operate, we strongly encourage you to turn on the Safety Mode. It is also important that you look at the display only if it is absolutely safe to do so. You should always observe traffic signs and road geometry before you obey any instruction from the NVXM1000. If you need to deviate from the recommended direction, the unit will suggest a modified route according to the new situation. Never place the NVXM1000 where it can obstruct the view of the driver, is within the deployment zone of airbags, or where it can cause injuries in case of an accident. General information Navigation with XM® Ready is a navigation system optimized for in-car use. It provides door-to-door navigation for both single and multi-point routes using adaptable route parameters. Navigation with XM® Ready is capable of planning routes throughout the whole map region installed on the memory card. Unlike some other products, the NVXM1000 does not require that you change maps or switch to a poorly detailed general map to navigate between map segments or countries. You always have complete freedom to go wherever you wish. Just insert the memory card and go. You do not need a stylus to use the NVXM1000. All screen buttons and controls are designed so that you can operate them with your fingertips. When using Navigation with XM® Ready, you do not need to 'double tap' or 'tap & hold' the touch screen as these functions cannot be used reliably in a moving vehicle. A single tap triggers most of the screen controls. The only exceptions are 'drag & drop' for moving the map, or scaling it in Map mode. Most of the screens have a Return button ( ) in the top left corner. This arrow returns to the previous screen or directly to one of the map screens. NOTICE TO DRIVERS IN CALIFORNIA AND MINNESOTA: State law prohibits drivers in California and Minnesota from using suction mounts on their windshields while operating motor vehicles. Other Audiovox dashboard mounting options should be used. Audiovox does not take any responsibility for any fines, penalties, or damages that may be incurred as a result of disregarding this notice. (See California Vehicle Code Section 26708(a); Minnesota Statutes 2005, Section 169.71) 3