Jensen VM9022HD Operation Manual - Page 6

VM9022HD Optional Equipment • NAV101 The VM9022HD is "navigation ready." Before accessing any navigation features, you must purchase and install the NAV101 module. All installation and operating instructions will be included with the NAV101 navigation module. Once the NAV101 is connected and operating properly, the NAV source mode will become active. While the NAV101 is not installed, the NAV option appears gray, indicating the function is not available. • Rear Camera The VM9022HD is "camera ready." Before accessing any camera features, you must purchase and install a rear video camera. Once the rear camera is connected and operating properly, the CAMERA source mode will become active. While the camera is not installed, the CAMERA option appears gray, indicating the function is not available. • Satellite Radio Tuner See "Satellite Radio Operation" on page 21. • jLinkCable and iPod See "MP3/WMA Operation" on page 27. • Bluetooth Phone See "Bluetooth Operation" on page 31. • 3.5mm to 3.5mm Audio Cable Sold separately at various retailers. What's in the Box 1. Left and Right Double DIN Mounting Brackets 2. Double DIN Half Sleeve Install Bracket 3. Remote Control with Battery 4. Rear Support Mounting Strap 5. jLink iPod Cable 6. HD Radio Module 7. HD Radio Module connecting DIN cable 8. HD Radio Module Mounting Hardware 9. Two Custom Cosmetic Trim Rings 10. Parking Brake Wire 11. MediaLink 12. Screen Cleaning Cloth 13. M5x6 and M3x4 Screws to Mount Radio to Brackets 14. Speaker Output Harness 15. Power Input Harness 16. Center Channel Wire Harness Tools and Supplies You will need these tools and supplies to install your VM9022HD: • Torx type, flat-head and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for power connections • 16 - 18 gauge speaker wire Disconnecting the Battery To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the VM9022HD is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit. WARNING! Only connect the unit to a 12-volt power supply with proper grounding. WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions. WARNING! To reduce the risk of a traffic accident (except when using for rear view video camera), never use the video display function while driving the vehicle. This is a violation of federal law. WARNING! Never disassemble or adjust the unit. WARNING! To prevent injury from shock or fire, never expose this unit to moisture or water. WARNING! Never use irregular discs. WARNING! To prevent damage to the mechanism inside this unit, avoid impact to the TFT monitor. WARNING! Using an improper fuse may cause damage to the unit and result in a fire. 2