Jensen VM9410 Owners Manual - Page 15

VM9410 ASP Config Adjusting a Feature 1. Enter the option field for the feature you want to adjust by pressing the button (18) on the remote or by pressing the ENTER (joystick) button (20) on the unit. A submenu appears in a second row with the selected option highlighted in light blue. 2. Select a new value by pressing the or buttons (14, 22) on the remote control or the or buttons (18, 19) on the joystick. 3. Confirm your selection by pressing the , , or buttons (14, 17, 19) on the remote control, or the or button (16, 17) on the joystick. The new value is highlighted in light blue and setup is complete. Table 8: ASP Config Menu Features Setting Options Function Bass Center Freq Treble Center Freq 60Hz 80Hz 100Hz 130Hz 150Hz 200Hz 10KHz 12.5KHz 15KHz 17KHz According to the audio source, select the Bass Center Frequency to achieve the best Bass effect. According to the audio source, select the Treble Center Frequency to achieve the best Treble effect. Table 8: ASP Config Menu Features Setting Options Function Sub.W Filter 80Hz 120Hz 160Hz Sub.W Phase 0D 180D Bass Q-Factor 1.0 1.25 1.5 2.0 Selecting a crossover frequency sets a cut-off frequency of the subwoofer's LPF (low-pass filter) and the "SMALL" speakers' HPF (high-pass filter). The Crossover frequency setting has no effect if the subwoofer is set to "OFF" and any other speaker is set to "LARGE". Subwoofer output IN phase Subwoofer output OUT OF phase NOTE: Depending on your installation, reversing the subwoofer phase may increase Bass output. When the Bass Center Frequency is selected, adjusting the Bass Q-Factor alters the sharpness of the Bass output. Return to previous menu Exiting the System Setup Menu To exit setup mode and resume normal playback, press the SYS SETUP button (31) on the remote control or the DSP button (5) on the front panel. 13