Kenmore 32956 Owners Manual - Page 18
ifa different
View all Kenmore 32956 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
NOTEI:t is notnecessartyo adjusthe upperthermostat. Howeveirf,it is adjusteadbovethefactorysetpoinot f 120°F (49°C)i,t is recommendtehdatit notbesethighetrhanthe lowerthermostaset tting. Temperature-Pressure Relief Valve Operation The temperature-pressure relief valve must be manually operated at least once a year. Theuppear ndlowerthermostaatrseadjustabilfea different watertemperaturies desired.Readall warningsin the "Temperature-Regulation" section before proceeding. • Burn hazard 1. Turn "OFF" the electric power to the water heater at the junction box. [ • Hotwater discharge. • Keep clear of relief valve discharge outlet. ,, Before removing any access panels or servicing the water heater, make sure the electrical supply to the water heater is turned "OFF". ,, Failure to do this could result in death, serious bodily injury, or property damage. The temperature-pressure relief valve must be manually operated at least once a year. Caution should be taken to ensure that (1) no one is in front of or around the outlet of the temperature-pressure relief valve discharge line, and (2) the water manually discharged will not cause any property damage or bodily injury. The water may be extremely hot. TEMPERATURE_PRESSURE 2. Take off the upper and/or lower access panel, insulation cap with handle. 3. The slotted adjustment (using a screwdriver) can be turned clockwise ( f'_ ) to increase the temperature setting or counter clockwise ( _'_ ) to decrease the temperature setting. 4. Replace the insulation cap with handle and access panel. 5. Turn "ON" the power supply. Anode Rod Inspection Property Damage Hazard • Avoid water heater damage. . Inspection and replacement of anode as needed. The anode rod is used to protect the tank from corrosion. Most hot water tanks are equipped with an anode rod. The submerged rod sacrifices itself to protect the tank. Instead of corroding the tank, water ions attack and eat away the anode rod. This does not affect the water's taste or color. The rod must be maintained to keep the tank in operating condition. Anode deterioration depends on the water conductivity, not necessarily water condition. A corroded or pitted anode rod indicates high water conductivity and should be checked and/ or replaced more often than an anode rod that appears to be intact. Replacement of a depleted anode rod can extend the life of your water heater. Inspection should be conducted by calling Sears Service Center. At a minimum the anode(s) should be checked annually after the warranty period. DISCHARGE PiPE FIGURE 28. If after manually operating the valve, it fails to completely reset and continues to release water, immediately close the cold water inlet to the water heater, follow the draining instructions, and replace the temperature-pressure relief valve with a new one. Failure to install and maintain a new properly listed temperaturepressure relief valve will release the manufacturer from any claim which might result from excessive temperature or pressure. If the temperature-pressure relief valve on the appliance weeps or discharges periodically, this may be due to thermal expansion. Your water heater may have a check valve installed in the water line or a water meter with a check valve. Consult your local Sears Service Center for further information. Do not plug the temperature-pressure relief valve. Draining . Burn hazard • Hot water discharge. • Keep hands clear of drain valve discharge. 18