Kenmore 32956 Owners Manual - Page 21
Hazard, Electric, Shock, result, damage.
View all Kenmore 32956 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
8. Clean the area around the element opening. Remove any sediment from or around the element opening, inside the tank. g. If you are cleaning the element you have removed, do so by scraping or soaking in vinegar or a de-liming solution. E Fire Hazard and Electric Shock Hazard " Do not use replacement elements with any voltage other than shown on the model rating plate. " Failure to use the correct voltage shown on the model rating plate could result in death, serious bodily injury, or property damage. Replacement elements must (1) be the same voltage and (2) no greater wattage than listed on the model rating plate affixed to the water heater. 10. A new gasket should be used in all cases to prevent a possible water leak. (See Element Gasket in the "Repair Parts List " Chart). Place the new element gasket on the thread side of the cleaned or new element and screw into tank, securing tightly using an element wrench. Never use this water heater unless it is completely full of water. To prevent damage to the tank and heating element, the tank must be filled with water. Water must flow from the hot water faucet before turning "ON" power. 14. Check element for water leaks. If leakage occurs, tighten element or repeat steps 2 and 3, remove element and reposition gasket. Then repeat steps 10 through 14. 15. Reconnect the two wires to the element and then check to make sure the thermostat surface of the tank. remains firmly against the FIGURE 38. 16. Replace terminal cover on thermostat making sure that the locking tabs on the terminal cover are in place. LIFT OUT TAB TO UNCLIP TERMINAL COVER FROM THERMOSTAT ( LOWER THERMOSTAT WITHOUT HIGH LIMIT FIGURE 37. 11. Close the water heater drain valve by turning the handle to the right (clockwise). The drain valve is on the lower front of the water heater. 12. Open the cold water supply valve to the water heater. NOTE: The cold water supply valve must be left open when the water heater is in use. 13. To insure complete filling of the tank, allow air to exit by opening the nearest hot water faucet. Allow water to run until a constant flow is obtained. This will let air out of the water heater and the piping. UPPER AND LOWER THERMOSTAT WITH HiGH LiMiT FIGURE 39. 17. Replace the insulation cap with handle so that it completely covers the thermostat and element. i-1 IQ improper installation and use may result in property damage. . Fill tank with water before operation. 21 FIGURE 40.