Kenmore 33205 Owners Manual - Page 17

4. Make sure that the plastic tubing is still attached from the air pressure switch to the port on the blower housing. Make sure the plastic tubing is not folded anywhere between the pressure switch and the blower housing. Make sure the ON/OFF switch is in the OFF position and that the outer harness is connected from the blower control box to the connector on the bottom side of the gas valve. If the outer harness is not factory installed, make sure the ON/OFF switch is in the OFF position and then connect the harness from the blower control box to the connector on the bottom side of the gas valve. Before servicing the water heater, make sure the blower assembly is unplugged or the electrical supply to the water heater is tumed "OFF". Label all wires prior to disconnection when servicing controls.Wiring errorcan cause improperand dangerous operation.Verify proper operation after servicing. Failure to do this could result in death, serious bedil injury,or propertydamage. 7. Do not plug in power cord until vent system is completely installed. This power vent heater operates on 110-120 Vac, therefore a grounded outlet must be within reach of the six (6) foot (1.8 m) flexible power cord supplied with the unit (see Figure 1). The power cord supplied may be used only where local codes permit. If local codes do not permit the use of a flexible power supply cord: a.) Make sure the unit is unplugged from wall outlet. Remove screws and open panel on front of control box. b.) Cut the flexible power cord, leaving enough to be able to make connections and remove the strain relief fitting from box. c.) Install suitable conduit fitting in side of enclosure and then follow (d.) and (e.) below. d.) Splice field wiring into existing wiring using code authorized method (wire nuts, etc.). e.) Be certain that neutral and live connections are not reversed when making these connections. f.) Close panel on the side of control box, make sure that access panel is secured shut. H GND i ONiOFF sw_ BLOWER VACUUM SWITCH (EXHAUST BLOCKAGE) JUNCTION BOX STUD HIGH AIR BLOWER HIGH AIR SWITCH I I I G _ TEMPERATURE (_ MOT_OR WATE_----- _ _ I HEATER CONTROL 6 PiN CONNECTOR _ :_2_J" _;_ _PZJ' F 4 PIN / CONNECTOR / FV SENSOR BLOWER ASSEMBLY MOUNTING SCREW (JACKET/TANK GROUND CONNECTION) X6WIRE CABLE ASSEMBLY FLAME SENSE ROD You must provide all wiring of the proper size outside of the water heater. You must obey local codes and electric utility requirements when you install this wiring. This appliance must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code NFPA 70 (current edition). Note: If any of the original wire as supplied with the appliance must be replaced, it must be replaced with 105°C wire or its equivalent. 17