Kenmore 4102 Installation Instructions - Page 7

white wire, or, Cabinet, Construction - dimensions

Get Kenmore 4102 - Elite 30 in. Slide-In Electric Range PDF manuals and user guides View all Kenmore 4102 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

WherelocalcodesDONOTpermitconnectingthe appliance-groundingconductorto the neutral (white) wire, or if connecting to 4-wire electrical system (see Figure 6): 1. Disconnect the power supply. 2. Separate the green (or bare copper) and white appliance cable wires. 3. In the circuit breaker, fuse box or junction box: connect appliance and residence cable wires as shown in figure 6. Green (or Bare Copper) Cable from Residence Junction Box White Wire (Neutral) _ Countertop Preparation • The cooktop sides of the range fit over the cutout edge of your countertop. • If you have a square finish (flat) countertop, no countertop preparation is required. Cooktop sides lay directly on edge of countertop. • Formed front-edged countertops must have molded edge shaved flat 3/4" (1.9 cm) from each front corner of opening (Figure 7). • Tile countertops may need trim cut back 3/ 4"(1.9 cm)from each front corner and/or rounded edge flattened (Figure 7). • If the existing cutout width is greater than 30 1/16" (76,4 cm), reduce the 3A" (1.9 cm) dimension. Black Green (or Bare Copper) Wire Cable from Appliance White Wire (Neutral) U.L.-listed Conduit Connector (or CSA listed) Figure 6 - 4-Wire Electrical System (Example: Junction Box) Cabinet Construction (__ To eliminate the risk of burns or fire by reaching over heated surface units, do not have cabinet storage space above the range. If there is cabinet storage space above range, reduce risk by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinet. Min. Cutout Width J (1.9cm) (1.9 cm) I (81 cm) Formed or tile countertop trimmed ¾" (1.9 cm) back at front corners of countertop opening. Figure 7 • Countertop must be level. Place a level on the countertop, first side to side, then front to back. If the countertop is not level, the range will not be level. The oven must be level for satisfactory baking results. Cooktop sides of range fit over edges of countertop opening. __ F(7o3r.7excimsti)ng(Figcuuretou8t): width of 29" You must also clear 2 3/16" (5.56 cm) of material from front of counterto .J_._ (3.2 cm) I Formed or tile countertop trimmed I_A '' (3.2 cm) back at front corners of countertop opening. Figure 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
WherelocalcodesDONOTpermitconnectingthe
appliance-groundingconductortotheneutral
(white) wire, or
if
connecting
to 4-wire
electrical
system
(see Figure
6):
1.
Disconnect the power supply.
2.
Separate the green (or bare copper) and white
appliance
cable wires.
3.
In the circuit
breaker, fuse box or junction
box:
connect appliance
and residence cable wires as
shown in figure 6.
Cable
from
Green
Residence
Junction
(or
Bare
Copper)
Box
Green
(or
Bare
Copper)
Wire
White
Wire
(Neutral)
Black
White
Wire
(Neutral)
U.L.-listed
Cable
from
Conduit
Appliance
Connector
(or
CSA listed)
Figure
6
-
4-Wire
Electrical
System
(Example:
Junction
Box)
Cabinet
Construction
(__
To eliminate
the risk of burns or fire
by reaching over heated surface units, do not have
cabinet
storage space above the range.
If there is
cabinet
storage space above range, reduce risk by
installing a range hood that
projects horizontally
a
minimum
of 5" (12.7 cm) beyond the bottom
of
the cabinet.
_
Countertop
Preparation
• The cooktop
sides of the range fit over the
cutout edge of your countertop.
• If you have a square
finish
(flat)
countertop,
no countertop
preparation
is required.
Cooktop
sides lay directly
on edge of countertop.
• Formed
front-edged
countertops
must have
molded edge shaved flat 3/4"
(1.9 cm) from
each front
corner of opening
(Figure 7).
• Tile
countertops
may need trim cut back 3/
4"(1.9
cm)from
each front
corner and/or
rounded
edge flattened
(Figure 7).
• If the existing
cutout
width
is greater
than
30 1/16"
(76,4
cm),
reduce
the
3A" (1.9
cm)
dimension.
Min.
Cutout
Width
J
(1.9cm)
(81cm)
Formed
or
tile
countertop
trimmed
¾" (1.9
cm)
back
at
front
corners
of countertop
(1.9 cm)
opening.
I
Figure
7
• Countertop
must
be
level.
Place a level
on
the
countertop,
first side to side, then front
to back. If the
countertop
is not level, the range will
not be level. The
oven
must
be level
for
satisfactory
baking
results.
Cooktop
sides of
range fit
over edges of countertop
opening.
_
_
For existing
cutout
width
of
29"
(73.7 cm) (Figure
8):
You
must
also
clear
2 3/16"
(5.56 cm) of
material
from
front
of counterto
.J_._
(3.2
cm)
I
Formed
or tile
countertop
trimmed
I_A '' (3.2 cm)
back
at front
corners
of
countertop
opening.
Figure
8