Kenmore 4102 Installation Instructions - Page 9
Leveling, Range - sears
View all Kenmore 4102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
If Accessories Needed : Installation For 29" Existing Cutout Width Opening 1. You must replace the actual side trims by new and smaller side trims. These new side panels can be ordered through a Sears Service Center. 2. Follow instructions supplied with your new side trims to replace the actual side trims with the new ones. 3. Check if the countertop is prepared for 29" cutout wide opening at page 7. 4. Install range as in the "Installation Without Side Panels" section above. Installation With Backguard A backguard kit can be ordered through a Sears Service Center.The cutout depth (21 3/4" (55.2 cm) Min., 22 1/8" (56.2cm) Max.) needs to be increased to24" (61 cm) when installing a backguard Installation With End Panel An end panel kit can be ordered through a Sears Service Center. Installation With Side Panel A side panels kit can be ordered through a Sears Service Center. Install cabinet doors 31 " (78.7 cm) rain. apart so as not to interfere with range door opening. Leveling the Range Models Equipped with Leveling Device _ Level the range after installation in the cutout opening. I. Open the range drawer. The leveling screws control the height of the rear leg. 2. Adjust the appliance legs as follows until the underside of the cooktop surface is sitting level on the countertop (Figure 9). a.To adjust the front legs, use a wrench on the leg base and turn clockwise to lower or counterclockwise to raise. b.To adjust the rear legs, use a ratchet or a nutdriver and turn the leveling screws counterclockwise to lower or clockwise to raise. 3. Check if the range is level by installing an oven rack in the center of the oven and placing a level on the rack (Figure 10). 4. Take 2 readings with the level placed diagonally in one direction and then the other. Level the range, if necessary, by adjusting the leveling legs. 5. If the range cannot be level, contact a carpenter to correct sagging or sloping floor. Models Equipped with Leveling Legs Level the range and set cooktop height before installation in the cut-out opening. I. Install an oven rack in the center of the oven. 2. Place a level on the rack (see Figure 10). Take 2 readings with the level placed diagonally in one direction and then the other. Level the range, if necessary, by adjusting the 4 leg levelers with a wrench (see Figure 16). 3. Taking care to not damage the countertop, slide range into cutout opening and double check for levelness. to Ad ust Rear Leveling Device H ig _t Screw-- Leveling _j Font Leveling Leg LOWER RAISE Figure 9 Figure 10