Kenmore 4123 Installation Instructions - Page 3
Important, Safety, Instructions - parts
View all Kenmore 4123 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the cooktop. 2. Remove all packing material before connecting the electrical supply to the cooktop. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions with your Use and Care Guide for future reference. IMPORTANT SAFETY INSTRUCTIONS • Be sure your cooktop is installed and grounded properly by a qualified installer or service technician. • These cooktops must be electrically grounded in accordance with local codes or, in their absence, with the National Electrical Code ANSI/NFPA No. 70--latest edition in the United States, or with CSA Standard C22.1, Canadian Electrical Code, Part 1, in Canada. 2. A circuit breaker of 40 Amp is recommended. NOTE: Wire sizes and connections must conform with the fuse size and rating of the appliance in accordance with the National Electrical Code ANSI/NFPA No. 70latest edition, and local codes and ordinances. An extension cord must not be used with this appliance. Such use may result in a fire, electrical shock, or other personal injury. 3. The appliance should be connected to the fused disconnect (or circuit breaker) box through flexible armored or nonmetallic sheathed cable. The flexible armored cable extending from this appliance should be connected directly to the grounded junction box. The junction box should be located as shown in Figure 2 with as much slack as possible remaining in the cable between the box and the appliance, so it can be moved if servicing is ever necessary. 4. A suitable strain relief must be provided to attach the flexible armored cable to the junction box. Unpacking Instructions _The electrical power to the cooktop must be shut off while line connections are being made. Failure to do so could result in serious injury or death. Provide Electrical Connection Install the junction box under the cabinet and run 120/ 240 or 120/208 Volt, AC wire from the main circuit panel. DO NOT connect the wire to the circuit panel at this time. Electrical Requirements Observe all governing codes and local ordinances. 1. A 3-wire or 4-wire single phase 120/240 or 120/208 Volt, 60 Hz AC only electrical supply is required on a separate circuit fused on both sides of the line (time-delay fuse or circuit breaker is recommended). DO NOT fuse neutral. // ,, // and Serial Plate rlgr"-ure3 (UnderCooktop) , Leave corner supports on cooktop until completion of Electrical Connection. 2. Be sure the bottle of cleaner conditioner packed in the literature bag is left where the user can find it easily. It is important that the ceramic-glass smoothtop be pretreated before use. See Cooktop Cleaning and Maintenance section in the Use and Care Guide. 3