Kenmore 4751 Use and Care Guide - Page 23

TROUBLESHOOTING First try the solutions suggested here to possibly avoid the cost of a service call... Error codes When all cycle indicator lights are blinking, see which status light is also illuminated and then check the list below for potential problem and troubleshooting checks. An error code may be shown in the Estimated Time Remaining display (on some models). • "Rinse" and "Clothes Clean" illuminated or "F20" on display (Water Inlet Problem--no water or insufficient water supply) Select STOP twice to cancel the cycle. Unplug washer or disconnect power. Check the following: Are water faucets completely turned on? Are screens at inlet hose connection water inlet hoses kinked? Are water inlet hoses frozen? to washer clogged? Are Noisy, vibrating, off-balance Is the washer level? The washer must be level. The four feet should be properly installed, and the nuts should be tightened against the washer cabinet. All four feet of the washer must be in firm contact with the floor. If the washer is on a pedestal, the washer must be secured to the pedestal and all four pedestal feet must be in firm contact with the floor. Washer making a different noise? As with any new product, you will hear sounds that you are not accustomed to. You may hear various sounds when the door is locked or unlocked, and during the washing, rinsing, or spinning process. Between changes in wash actions, there will be momentary pauses. You will hear water spraying and splashing during the wash and rinse cycles. These new sounds and pauses are part of normal washer operation. Is washer installed on a sturdy and solid floor? Refer to the "Installation Instructions" for flooring requirements. Noise and vibration may be reduced by placing a piece of 3A" (19.1 mm) plywood underneath your washer. The plywood may extend underneath both washer and dryer to keep them at equal heights. Is the washer gurgling or humming? As water is drained from the washer, you may hear air being pulled through the pump. This happens during the end of draining. It is normal. Are you washing items with metal snaps, buckles or zippers? You may hear metal items touching the washer drum. This is normal. can result in death, Were the 4 shipping bolts in the back of the machine removed? See "Remove Transport System." Electrical Plug into a grounded Do not remove ground Shock Hazard 3 prong outlet. prong. Do not use an adapter. Do not use an extension Failure to follow fire, or electrical cord. these instructions shock. Plug in washer or reconnect power. Re-select cycle and press START. If the problem remains, call for service. "Add a Garment," "Rinse" and "Clothes Clean" illuminated or "F21" on display (Drain Problem) Select STOP twice to cancel the cycle. Unplug washer or disconnect power. Check the following: Is the drain hose kinked? Is the drain hose frozen? Is the drain hose clogged? Is the drain hose more than 96" (2.4 m) above the floor? Any other Status light combination (Electrical Problem) Select STOP twice to cancel the cycle. Select RINSE/DRAIN & SPIN, and then select 2ND RINSE (to turn off the rinse option) if there is excessive water in the washer. Re-select cycle and press START. If the problem remains, call for service. 23