Kenmore 60581 Use and Care Guide - Page 1

Kenmore 60581 - 3/4 HP Food Waste Disposer Manual

Page 1 highlights

f ® FOOD WASTE DISPOSERS Installation, Care & Use Manual TOOLS AND MATERIALS YOU WILL NEED: Slotted Screwdriver, Adjustable Pliers, Plumber's Putty, Electrical Tape TOOLS, MATERIALS, AND ACCESSORIES YOU MAY NEED: Phillips Screwdriver, Drain Auger, 3/8" Electrical Clamp Connector, Wire Nuts (2), Second 1 1/2" Drain Trap, Hammer, Hacksaw, Water Hose Clamp, Pipe Wrench, Copper Ground Wire, Dishwasher Drain Connection Kit, Air Gap, Electrical On/Off Switch, Drain Tube Extension Read through the entire Installation, Care & Use manual before installing the disposer. Determine which of the tools, materials, and accessories you will need before you begin. Make sure you have all necessary disposer parts before installing the disposer (see part identification diagram below). (_/A JlB O--c _ #1 OR @-N .-0 O--G Mounting Assembly A: Stopper B: Sink Flange C: Fiber Gasket D: Backup Ring E: Mounting Ring F: Screws (3) G: Snap Ring Disposer H: Mounting Gasket/Splash Baffle 1: Lower Mounting Ring J: Dishwasher Inlet K: Discharge Outlet L: Wrenchette --#2 ___N Two-Bolt Discharge N: Bolt (2) _10: Discharge Tube (1-1/2" Diam.) P: Flange Q: Gasket OR One-Bolt Discharge N: Bolt #20:DischargeTub(1e-1/2" Diam.) P: Flange Q: Gasket SAFETY SYMBOLS Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. It" WARNINGIWarning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. [_kCAUTION] Caution indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury,

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

f
®
FOOD WASTE
DISPOSERS
Installation,
Care & Use Manual
TOOLS
AND
MATERIALS
YOU WILL
NEED:
Slotted Screwdriver,
Adjustable
Pliers, Plumber's
Putty,
Electrical
Tape
TOOLS,
MATERIALS,
AND ACCESSORIES
YOU MAY NEED:
Phillips
Screwdriver,
Drain Auger, 3/8" Electrical
Clamp
Connector,
Wire Nuts (2), Second 1 1/2" Drain Trap,
Hammer,
Hacksaw, Water Hose Clamp,
Pipe Wrench,
Copper Ground Wire, Dishwasher
Drain Connection
Kit, Air
Gap, Electrical
On/Off Switch,
Drain Tube Extension
Read
through
the
entire
Installation,
Care
& Use
manual
before
installing
the
dis-
poser.
Determine
which
of the
tools,
materials,
and accessories
you will need
before
you
begin.
Make
sure
you
have
all
necessary
disposer
parts
before
install-
ing the
disposer
(see
part
identification
diagram
below).
(_/A
JlB
O--c
O--G
Mounting
Assembly
A: Stopper
B: Sink Flange
C: Fiber Gasket
D: Backup
Ring
E: Mounting Ring
F: Screws (3)
G: Snap
Ring
Disposer
H: Mounting
Gasket/Splash
Baffle
1: Lower Mounting Ring
J: Dishwasher Inlet
K:
Discharge
Outlet
L: Wrenchette
_
@-N
#1
.-0
OR
--#2
___N
Two-Bolt
Discharge
N:
Bolt
(2)
_10:
Discharge Tube (1-1/2"
Diam.)
P: Flange
Q:
Gasket
OR
One-Bolt
Discharge
N:
Bolt
#20:DischargeTube
(1-1/2" Diam.)
P: Flange
Q:
Gasket
SAFETY
SYMBOLS
Danger indicates
an
imminently
hazardous
situation
which,
if not avoided,
will result in death or
serious
injury.
I
t"
WARNINGI
Warning
indicates
a
potentially
hazardous
situation
which, if not avoided, could result in
death
or serious injury.
[_kCAUTION]
Caution
indicates a
potentially
hazardous
situation
which,
if not
avoided,
may result in minor or
moderate
injury,