Kenmore 7748 Use and Care Guide - Page 11

Setting, Oven Controls

Page 11 highlights

Setting Oven Controls yf 0 • • • ® _ ® • ® j- Note: The time of day must first be set in order to operate the oven. To Set the Clock When the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash "12:00". 1. Press once (do not hold pad down). 2. Within 5 seconds, press and hold the A or V until the correct time of day appears in the display. Note: The clock cannot be changed during any timed bake or Self-Clean cycle. ii.i.......... To Set the Minute Timer: 1. Press @. , Press the A to increase the time in one minute increments. Press and hold the A to increase the time in 10 minute increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes. Note: If the V pad is pressed first, the timer will advance to 11 hours and 59 minutes. 3. The display shows the timer countdown in minutes until 1 minute remains. Then the display will countdown in seconds. 4. When the set time has run out, the timer will beep 3 times and will continue to beep 3 times every 60 seconds until is pressed, Note: The indicator light located above the _ pad will glow while the minute timer is active. Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer is in use with any other function, the minute timer will be shown in the display. To view other functions, press the pad for that function. To Change the Minute Timer while it is in use: While the timer is active and shows in the display, press and hold the A or V to increase or decrease the time. To Cancel the Minute Timer before the set time has run out: Press _. once) and then release: This feature does not remove the set time of day from the memory of the control. When the display is ruined OFF the time 0f day Will [eiappea[ f0[ a few sec0nd s anytim e the _pa 11 d is t0Uched

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26

Setting
Oven Controls
yf
_
0
®
®
®
j-
Note: The time of day must
first be set in order to operate the oven.
To Set the
Clock
When the range is first plugged in, or when the power supply to the range has been interrupted,
the display will flash
"12:00".
once (do not hold pad down).
1.
Press
2.
Within 5 seconds,
press and hold the A
or V
until the correct
time of day appears
in the display.
Note: The clock cannot be changed during any timed bake or Self-Clean
cycle.
To
Set the
Minute
Timer:
1.
Press
@.
,
Press the
A
to increase
the time in one minute increments.
Press and hold the A
to increase the time in 10
minute increments.
The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
Note:
If the V
pad is pressed first, the timer will advance to 11 hours and 59 minutes.
3.
The display shows the timer countdown
in minutes until 1 minute remains. Then the display will countdown
in seconds.
4.
When the set time has run out, the timer will beep 3 times and will continue to beep 3 times every 60 seconds until
is pressed,
Note:
The indicator light located above the _
pad will glow while the minute timer is active.
Note:
The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set
time has run out. The minute timer can be used alone or during any of the other oven functions.
When the minute timer is in
use with any other function,
the minute timer will be shown in the display. To view other functions,
press the pad for that
function.
To Change
the Minute
Timer
while it is in
use:
While the timer is active and shows in the display, press and hold the A
or
V
to increase or decrease
the time.
iii
...........
To
Cancel
the
Minute Timer
before
the set time
has run out:
Press
_.
once)
and then release: This feature does not remove the set time of day from
the
memory of the control. When the display
is ruined
OFF the time 0f day Will [eiappea[
f0[ a few sec0nd s anytim
e
the _pa
d is t0Uched
11