Kenmore 7756 Use and Care Guide - Page 37

Removing, & Replacing, Instructions, & Cleaning, Stainless, Steel, models

Page 37 highlights

General Care & Cleaning • Removing & Replacing Lift-Off Oven Door • DoorCare Instructions • Care & Cleaning of Stainless Steel (some models) Door Hinge locations with oven door fully open Fig. 1 Removing & Replacing the Lift-Off Oven Door The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. To Remove Oven Door: 1. Open oven door completely (horizontal with floor- See Fig. 1). 2. Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Fig. 2). A tool such as a small flat-blade screwdriver may be required. 3. Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3). 4. Close the door to the broil stop position (the oven door will stop into this position just before fully closing). 5. With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Fig. 4). Fig. 2 Oven Door- Fi 1.3 To Replace Oven Door: 1. Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3). 2. Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins. 3. Fully open the oven door (horizontal with floor- See Fig. 1). 4. Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Fig. 2) to the locked position. 5. CIose the oven door. Door Care Instructions Most oven doors contain glass that can break. Read the following recommendations: 1. Do not close the oven door until all the oven racks are fully in place. 2. Do not hit the glass with pots, pans, or any other object. 3. Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time. ii.i........... Care & Cleaning of Stainless Steel (some models) Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions. Fig. 4 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

General Care & Cleaning
Removing & Replacing Lift-Off Oven Door
DoorCare
Instructions
Care & Cleaning of Stainless Steel (some models)
Fig. 2
Oven
Door-
Fi
Door
Hinge
locations
with
oven
door
fully
open
Fig. 1
1.3
Fig. 4
Removing
& Replacing
the
Lift-Off
Oven
Door
The door is heavy. For safe, temporary
storage, lay the door flat
with the inside of the door facing down.
To
Remove
Oven Door:
1.
Open oven door completely
(horizontal
with floor-
See Fig. 1).
2.
Pull the door hinge locks on both left and right door hinges down from the
oven frame completely
towards the oven door (See Fig. 2). A tool such as a
small flat-blade
screwdriver
may be required.
3.
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
4.
Close the door to the broil stop position (the oven door will stop into this
position just before fully closing).
5.
With the oven door in the broil stop position, lift the oven door hinge arms over
the roller pins located on each side of the oven frame (See Fig. 4).
To Replace
Oven Door:
1.
Firmly grasp both sides of oven door along the door sides (Do not use the
oven door handle - See Fig. 3).
2.
Holding the oven door at the same angle as the removal position, seat the
hook of the hinge arm over the roller pins located on each side of the oven
door frame (See Fig. 4). The hook of the hinge arms must be fully seated
onto the roller pins.
3.
Fully open the oven door (horizontal
with floor-
See Fig. 1).
4.
Push the door hinge locks up towards and into the oven frame on both left
and right oven door hinges (See Fig. 2) to the locked position.
5.
CIose the oven door.
Door
Care
Instructions
Most
oven doors
contain
glass
that
can break.
Read the following
recommendations:
1.
Do not close the oven door until all the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching,
hitting, jarring or stressing
the glass may weaken
its structure
causing
an increased
risk of breakage at a later time.
Care
& Cleaning
of
Stainless
Steel
(some
models)
Some models are equipped with stainless steel exterior parts. Special care and
cleaning are required
for maintaining
the appearance
of stainless parts. Refer to
the Care & Cleaning
Table for detailed
cleaning instructions.
iii
............
37