Kenmore 8804 Installation Instructions - Page 11
Electricalconnections, Electricalconnections For 4- Wire System, For 3- Wire System, Usa
View all Kenmore 8804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ELECTRICALCONNECTIONS FOR 3- WIRE SYSTEM USA ELECTRICDryer 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a U.L approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. GREEN SCREW NEUTRAL GROUND WIRE SILVER TERMINAL ELECTRICALCONNECTIONS FOR 4- WIRE SYSTEM USA ELECTR/CDryer l 1. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. 2. Install a U.L approved strain relief in the entry hole of the mounting bracket. Finger tighten the nut only at this time. 3. Remove the ground wire from the green ground screw located above the terminal block. GREEN SCREW GREEN POWER CORD SILVERTERMINAL TERMINAL BLOC K tUTTIGHTEN NUT TO THESE _READS BRACKET POWER CORD 3. Thread a U.L approved 30 amp. power cord, NEMA 10-30 type SRDT,through the strain relief. 4. Attach the power cord neutral (center wire) conductor to the silver colored center terminal on the terminal block. Tighten the screw securely. 5. Attach the remaining two power cord outer conductors to the outer brass colored terminals on the terminal block. Tighten both screws securely. Do not make a sharp bend or crimp wiring/ conductor at connections. 6. Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten screws securely. GROUND WIRE WHITE NUT TIGHTEN NUT TO THESE -HREADS STRAIN RELIEF BRACKET,. POWER CORD 4. Thread a U.L approved 30 amp power cord, NEMA 14-30 type ST or SRDTthrough the strain relief. TYPICAL 4 TYPICAL 4 C_WHITE 30 AMP NEMA 14-30 TYPE SRDT OR ST BLACK _,_I_ED _GREEN . Attach the green power cord ground wire to the cabinet with the green ground screw. . Attach the white (neutral) power cord conductor from the power cord and the neutral ground wire from the dryer harness to the silver-colored center terminal on the terminal block. Tighten the screw securely. 7. Tighten the screws securing the cord restraint firmly against 7. Attach the red and black power cord conductors to the outer the power cord. brass-colored terminals on the terminal block. 8. Tighten the strain relief nut securely so that the strain relief does not turn. 9. Reinstall the terminal block cover. Do not make a sharp bend or crimp wiring/ conductor at the connections. . Tighten the screws securing the cord restraint firmly against the power cord. 9. Tighten the strain relief nut securely so the strain relief does not turn. 10.Reinstall the terminal block access cover. 11 Printed in U.S.A.