Kenmore 8804 Installation Instructions - Page 7
Installation - dryer parts
View all Kenmore 8804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
MOBILE HOME INSTALLATION I. Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. 2. If dryer is exhausted through the floor and area beneath the mobile home isenclosed, the exhaust systemMUSTterminate outside the enclosure with the termination secu rely fastened to the mobile home structure. 3. When installing a gas dryer into a mobile home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. 4. This dryer MUST be fastened to the floor. Mobile Home Installation Kit No. 346764 is available from your dealer. 5. Refer to pages 2 and 3 for other important venting requirements. 6. Installation MUSTconform to current Manufactured Home Construction & Safety Standard (which is a FederalRegulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. The dryer is designed under ANSI Z 21,5,1 or ANSI/UL2158- CAN/CSA C22.2 (latest editions) for HOME USE only. UNPACKING Using the four shipping carton corner posts (two on each side), carefully lay the dryer on its left side and remove the foam shipping base. To prevent damage, do not use the control panel as a means to pick up or move the dryer. 2. Return the dryer to an upright position. _) FOAM SHIPPING PAD DO Correct i l ii ill _ i © Incorrect !iii_iiiiiil i_ii!iiii!i!i 7