Kenmore AC2044-1 Operation Manual - Page 11

MAINTENANCE, Washing, of Hot Water; Recommended, Fig. 3, gloves, protect your

Get Kenmore AC2044-1 - Electrostatic Air Cleaner PDF manuals and user guides View all Kenmore AC2044-1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

MAINTENANCE Washing Cell in a Tub of Hot Water; Recommended Method (See Fig. 3) 1. Fill a tub large enough to hold the entire cell with hot water (140 ° to 160°F.) and add detergent. Use a mild dishwashing liquid that is non-chlorine and non-abrasive. Agitate the solution for proper mixture. NOTE: Wear gloves to protect your hands. 2. Hold the bale handles on the cell and let it soak for about 10 minutes and then remove cell. 3. Now take cell and dip it in the solution several times to remove any final particles of dirt. 4. Thoroughly rinse by placing the cell in a tub of clean hot water. 5. Remove the cell and place in a position to drain all the excess water. 6. ALLOW THE CELL TO DRY THOROUGHLY. A hand-held dryer may be used to speed dry cell after washing. 7. Carefully place cell back into the air cleaner and swing handles inward. 8. Follow instructions RE-INSTALLING CLEAN PRE-FILTER to complete installation (See page 9). 9. Plug the Air Cleaner into a properly grounded 3-prong outlet. 10. Press Power On Button. 11. Press Check Button to reset it. IMPORTANT: NEVER use any tool, brush or similar object to clean between the collector plates in the cell. Doing this can damage the fine ionizing wires or the collector plates. NEVER place the cell in an oven to dry. Fig. 3 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
MAINTENANCE
Washing
Cell
in a
Tub
of Hot Water; Recommended
Method
(See
Fig. 3)
1. Fill a tub large enough to hold the entire cell with hot water (140 ° to
160°F.) and add detergent. Use a mild dishwashing
liquid that is
non-chlorine
and non-abrasive.
Agitate the solution for proper mixture.
NOTE:
Wear
gloves
to
protect your
hands.
2. Hold the bale handles on the cell and let it soak for about
10 minutes and then remove cell.
3. Now take cell and dip it in the solution
several times to
remove any final particles
of dirt.
4. Thoroughly
rinse by placing the cell in a tub of clean hot water.
5. Remove the cell and place in a position to drain all the excess water.
6.
ALLOW THE CELL TO DRY THOROUGHLY.
A hand-held
dryer may be used to speed dry cell after washing.
7. Carefully
place cell back into the air cleaner and swing handles inward.
8. Follow instructions
RE-INSTALLING
CLEAN
PRE-FILTER
to complete
installation
(See page 9).
9. Plug the Air Cleaner
into
a properly grounded
3-prong outlet.
10. Press Power On Button.
11. Press Check Button to reset it.
IMPORTANT:
NEVER use any tool, brush
or
similar object to clean between
the collector
plates in the cell. Doing this can damage the fine ionizing wires
or the collector
plates. NEVER place the cell in an oven to dry.
Fig.
3
11