Kenwood CS-7070ES User Manual - Page 4

Connections Note on connection 1. Be sure to turn off your amplifier before connecting or disconnecting speaker. 2. This speaker system has a nominal impedance of 8 ohms. To ensure safe and reliable operation, be sure that your amplifier or receiver (audio video control center) is able to work with 8-ohm speaker. • Never short the (+) and (-) speaker wire's conductors together. • Do not reverse (+) and (-) connections. Reversal of polarities may result in unnatural sound. ENGLISH 1 Loosen RED + WHITE - R FRONT A L Wire with white line GREEN 2 Insert the conductor 3 Secure 1 2 CENTER The speaker wire can also be connected to the speaker by using banana plugs which are commercially available in audio stores. To use the banana plug connection, tighten the screws on the speaker terminals before inserting the banana plug. Speaker terminals (Amplifier or Audio Video control center) Note on operation The speaker system's peak input power is indicated in the specifications. To avoid speaker damage, never run the speaker at power levels exceeding this limit. Specifications System 2 way 3 speakers (Magnetically shielded) Enclosure Acoustic Air Suspension Woofer 80 mm (3") Cone type × 2 Tweeter 19 mm (3/4") Dome type Nominal Impedance 8 Ω Peak Input Power 130 W Sensitivity 79 dB / W at 1 m Frequency Response 60 Hz~100 kHz Dimensions Width 400 mm (15-3/4") Height 102 mm (4") Depth 136 mm (5-3/8") Net Weight 3.0 kg (6.6 lb) /piece Accessories Speaker wire (4 m(13 ft 1 Cushion 4 (1 sheet) Note: KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice. 4 EN