Kenwood DDX318 Installation Manual - Page 7
Installing the Microphone Unit, DDX418/DDX4048BT only, Removing the Unit - installation
UPC - 019048192561
View all Kenwood DDX318 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Removing the Unit 1 Remove the escutcheon by referring to the removal procedure in the section . 2 Insert the two removal tools 6 deeply into the slots on each side, as shown. Accessory 6 3 Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. Installing the Microphone Unit (DDX418/DDX4048BT only) 1 Check the installation position of the microphone (accessory 7). 2 Remove oil and other dirt from the installation surface. 3 Install the microphone. 4 Wire the microphone cable up to the unit with it secured at several positions using tape or the like. ⁄ • Install the microphone as far as possible from the cell-phone. Accessory 7 ⁄ • Be careful to avoid injury from the catch pins on the removal tool. 4 Pull the unit all the way out with your hands, being careful not to drop it. Fix a cable with a commercial item of tape. Peel the release coated paper of double-face adhesive tape to fix on the place shown above. Adjust the direction of the microphone to the driver. English 7