Kenwood DDX896 Instruction Manual - Page 117
Error, When the unit fails to operate correctly, the cause of the failure appears on the, display. - wiring
UPC - 019048188434
View all Kenwood DDX896 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Help? Error When the unit fails to operate correctly, the cause of the failure appears on the display. "Protect" : Protective circuit has been activated because a speaker cord has shorted or it has come in contact with the car chassis. ➡ Wire or insulate the speaker cord as appropriate and then push the Reset button. "Hot Error" : When the internal temperature of this unit rises to 60°C or more, the protection circuit is activated and you may not be able to operate the unit. At such times this message will appear. ➡ Use the unit again after reducing the temperature inside the vehicle. "Mecha Error" : The disc player is malfunctioning. ➡ Eject the disc and try inserting it again. Contact the Kenwood dealer if this indicator continues blinking or the disc cannot be ejected. "Disc Error" : An unplayable disc is inserted. "Read Error" : Disc is quite dirty. ➡ Clean the disc, referring tot he section on (page 4). Disc is upside down. ➡ Load the disc with the labeled side up. "Region code Error" : The disc you wanted to play has a region code that cannot be played with this unit. "Parental level Error" : The disc you wanted to play has a higher level than the parental level you set. "Error 07-67" : The unit is not operating correctly due to some reason or other. ➡ Push the unit's Reset button. If the "Error 07−67" message does not disappear, see your nearest Kenwood dealer. "No Device" (USB device): The USB device is selected as a source although no USB device is connected. ➡ Change the source to any source other than USB/iPod. Connect an USB device, and change the source to USB again. "Disconnected" (iPod, Bluetooth audio player): The iPod/Bluetooth audio player is selected as a source although no iPod/Bluetooth audio player is connected. ➡ Change the source to any source other than iPod/Bluetooth. Connect an iPod/Bluetooth audio player, and change the source to iPod/Bluetooth again. "No Music" : The connected USB device contains no playable audio file. Media was played that doesn't have data recorded that the unit can play. "USB Device Error!!" : The connected USB device is rated a current capacity higher than the allowable limit. ➡ Check the USB device. Some trouble may have occurred to the connected USB device. ➡ Change the source to any source other than USB. Remove the USB device. "Authorization Error" : Connection to the iPod has failed. ➡ Remove the iPod and then reconnect it. The unit does not support the iPod. ➡ Refer to (page 7). DDX series DDX896/ DDX8046BT Next page 3 English 117