Kenwood DNR8025BT Instruction Manual - Page 138
Controlling General Audio, DSP select
![]() |
View all Kenwood DNR8025BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
ÑÑDSP select You can select whether using DSP (Digital Signal Processor) System. 1 Touch [Bypass] or [Through] of [DSP Select] in the Audio SETUP screen. Return to the Top page Controlling Audio 4 Set each item as follows. Bypass There is no effect by DSP. Through There is an effect by DSP. NOTE • When the mode is set to [Bypass], DSP System cannot be adjusted. Controlling General Audio 1 Touch [ ] on any screen. 2 Touch [Audio]. Audio screen appears. 3 Touch [Audio Control]. Fader # / Balance # Adjust the volume balance around the touched area. [C] and [D] adjust the right and left volume balance. [R] and [S] adjust the front and rear volume balance. Volume Offset* Finely adjust the volume of the current source to minimize the difference in volume between different sources. Subwoofer Level Adjust the subwoofer volume. This setting is not available when subwoofer is set to "None". See Speaker setup (P.135). Bass Boost Set the amount of bass boost among "OFF"/ "Level1"/ "Level2"/ "Level3". * If you have increased the volume first, then reduced the volume using the "Volume Offset", the sound generated if you suddenly switch to another source may be extremely loud. 137
![](/manual_guide/products/kenwood-dnn6250dab-instruction-manual-e8fa5bf/138.png)