Kenwood DNX570HD Instruction Manual - Page 126
Error Messages, Other - bluetooth problems
View all Kenwood DNX570HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Return to the Top page Troubleshooting Problem The sound skips when an audio file is being played. Reason The disc is scratched or dirty. The recording condition is bad. Solution Clean the disc. See Precautions on handling discs (P.4). Record the file again or use another disc. Other Problem The Touch Sensor Tone doesn't sound. Reason Solution The preout jack is being The Touch Sensor Tone cannot be output used. from the preout jack. Error Messages When you fail to operate the unit correctly, the cause of the failure appears as the message on the screen. Error Message Cause Solution Protect Protective circuit has been activated Wire or insulate the speaker cord as because a speaker cord has shorted appropriate and then push the or it has come in contact with the button (P.127). car chassis. Hot Error When the internal temperature of this unit rises to 60°C or more, the protection circuit is activated and you may not be able to operate the unit. Use the unit again after reducing the temperature of the unit. Mecha Error The disc player is malfunctioning. Eject the disc and try inserting it again. Contact the Kenwood dealer if this indicator continues blinking or the disc cannot be ejected. Disc Error An unplayable disc is inserted. Change the disc. See Playable Media and Files (P.128). Read Error The disc is quite dirty. Clean the disc. See Precautions on handling discs (P.4). Disc is upside down. Load the disc with the labeled side up. Region Code Error The disc you wanted to play has a See Region Codes in the World (P.133) or region code that cannot be played try another disc. with this unit. Parental Level Error The disc you wanted to play has a Set the parental level. higher level than the parental level See Parental level (P.29). you set. Error 07-67 The unit is not operating correctly due to some reason or other. Push the unit's Reset button. If the "Error 07−67" message does not disappear, see your nearest Kenwood dealer. No Device (USB device, Bluetooth audio player) The USB device is selected as a source although no USB device is connected. Change the source to any source other than USB/iPod. Connect a USB device, and change the source to USB again. 125