Kenwood KCA-S210A User Manual - Page 2

Connection ˙ Components 1Switching unit 1 2Controller (cord length: 5 m 1 3Connection cable (2 m 1 4Velcro strip 2 5Self-tapping screw(φ 4 × 16 mm).........2 6Cable band 1 7Double-sided adhesive tape 1 ˙ Connection 2CAUTION If you connect a model which can switch between disc changers 1 and 2 by the centre unit (Unit group B/C/D), the controller2 must not be connected. If it is connected, the disc changers may not work properly. Centre unit Controller2 TO CONTROLLER To the external unit AV IN Switching unit1 (Rear side) SWITCH SWITCH AUX IN PROTOCOL AUX O N OFF ON TO TO TO H/U CHANGER 1 CHANGER 2 TO TO CONTROLLER H/U TO CHANGER 1 TO CHANGER 2 Switching unit1 (Front side) Connection cable3 CD changer Connection cable (supplied with the CD changer) Connection cable (supplied with the MD changer) MD Changer NOTE • After connecting the equipment, press the reset button on the centre unit. • The figure shows that one CD changer and one MD changer are connected. Two CD changers or two MD changers may be connected. • A disc player such as the KDC-D300 may be connected instead of the disc changer. • If you wish to adjust the cable length in accordance with the installation location of the switching unit, such as in the trunk space, the disc changer extension cable may be used instead of the connection cable3. IMPORTANT INFORMATION This unit is NOT designed to be connected directly to a CD changer that was manufactured and sold before 1994. If you plan to use such units, please read the following information carefully. • To control KDC-C600/ KDC-C800/ KDC-601/ KDC-401 A CA-DS100 (sold separately as an optional accessory), along with the extension cord supplied with the CD changer, are required. • KDC-C200/ KDC-C300/ KDC-C301/ KDC-C400/ KDC-C100/ KDC-C302/ C205/ C705 and CD changer Manufactured by Other Companies are not compatible with this Kenwood model. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN DAMAGE TO THIS UNIT AND/OR THE CD CHANGER. 2-English