Kenwood KCA-S210A User Manual - Page 4

Installation ˙ Installing the switching unit with a board in the trunk space Self tapping screw5 (φ 4 × 16 mm) Cable band6 Switching unit1 Board etc. thickness: 17mm or more 1. Install the switching unit with self-tapping screws5 (φ 4 × 16 mm). 2. Bind the cables with cable band6. ˙ Installing the switching unit on the carpet under a seat Switching unit1 ;;;;; Velcro strips4 ;;;;;;;;;; carpet Cable band6 1. Remove the backing from the Velcro strips4 and attach it to the bottom of the switching unit1. Install the switching unit on the carpet. 2. Bind the cables with cable band6. 2CAUTION • Install the switching unit1 in places that do not obstruct driving. • Install the switching unit1 in places where it is not touched by the tip of the shoes of a rear seat passenger. • Do not install the unit in places where it is exposed to direct sunlight, high heat, or where water may splash over it. • Do not place anything on top of the switching unit 1. ˙Installing the controller Controller2 Double-sided adhesive tape7 1. Wipe off the installation location with a cleaning cloth. 2CAUTION • Install the controller2 on a flat surface. If it is installed on a curved surface, the tape adhesion may weaken and the controller may come off. • Do not install the controller2 in places (such as on the dashboard) where it is exposed to direct sunlight and the temperature becomes high. Otherwise, the controller2 will become deformed and unusable. • Install the controller2 in places that do not obstruct driving. Install the controller2 temporarily and verify that the handle, shift knob, and side brake can be operated smoothly. 2. Secure the controller2 in the specified place with the double-sided adhesive tape7. 4-English