Kenwood KDC-248U Instruction Manual - Page 14

Troubleshooting Symptom Remedy/Cause Sound cannot be heard. Adjust the volume to the optimum level. / Check the cords and connections. "PROTECT" appears and no operations can Check to be sure the terminals of the speaker leads are covered with insulating be done. tape properly, then reset the unit. If "PROTECT" does not disappear, consult your nearest service center. The unit does not work at all. Reset the unit. Radio reception is poor. / Static noise while Connect the antenna firmly. / Pull the antenna out all the way. listening to the radio. "IN" flashes. The CD player is not operating properly. Reinsert the disc properly. If the condition did not improve, turn off the unit and consult your nearest service center. CD-R/CD-RW cannot be played back and Insert a finalized CD-R/CD-RW (finalize with the component which you used for tracks cannot be skipped. recording). Disc sound is sometimes interrupted. Stop playback while driving on rough roads. / Change the disc. / Check the cords and connections. "NA FILE" appears. The unit is playing an unsupported audio file. "NO DISC" appears. Insert a playable disc into the loading slot. "TOC ERROR" appears. The CD is quite dirty. / The CD is upside-down. / The CD is scratched a lot. Try another disc instead. "ERROR 99" appears. The unit is malfunctioning for some reason. Press the reset button on the unit. If the "ERROR 99" code does not disappear, consult your nearest service center. "COPY PRO" appears. A copy-protected file is played. "READ ERROR" appears. Copy the files and folders for the USB device again. If the error message is still displayed, initialize the USB device or use other USB devices. "NO DEVICE" appears. No USB device is connected. Connect an USB device, and change the source to USB again. "NO MUSIC" appears. The connected USB device contains no playable audio file. "NA DEVICE" appears. Connect a supported USB device, and check the connections. "USB ERROR" appears. Remove the USB device, turn the unit off, then turn it on again. If the unit still showing the same display, try to connect another USB device. "iPod ERROR" appears. Reconnect the iPod. / Confirm that the software for the iPod is the latest version. Noise is generated. Skip to another track or change the disc. Tracks cannot play back as you have intended them to play. Playback order is determined when files are recorded. "READING" keeps flashing. Longer readout time is required. Do not use too many hierarchies and folders. Elapsed playing time is not correct. This is caused by how the tracks are recorded. The number of songs contained in "SONGS" Podcast files are not counted in this unit as this unit does not support the category of this unit is different from that playback of podcast files. contained in "SONGS" category of iPod. Correct characters are not displayed (e.g. This unit can only display letters (upper case), numbers, and a limited number album name). of symbols. 14