Kenwood KDC-D300 Instruction Manual - Page 10

Installation Procedure The O-N switch should be set according to the Centre unit in use as well as to the connected models. When the centre unit is compatible with the "N"-operation, set the O-N switch to "N". When it is not compatible with the "N"operation, set the O-N switch to "O" because the operation is not available. The initial setting of the switch is "N". Connections Centre unit English White/Black White - - 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Set the O-N switch of this unit to suit the centre unit. 3. Connect the speaker input cable to the front speaker cable of the wiring hernees of the centre unit. 4. Connect the control cable to the control connector. 5. Install the unit in your car. 6. Reconnect the - battery. 7. Press the reset button on the centre unit. 2CAUTION • Do not connect the changer control cable while the centre unit is turned ON. • Be sure to press the reset button after installation. • Whether the centre unit in use is compatible with the "N"- operation or not can be identified by referring to its instruction manual (description of the disc control mode, etc.). • When this unit is connected with the KCA-S200 changer switching unit, set the O-N switch to "O". • Do not let unconnected wires or terminals touch metal on the car or anything else conducting electricity. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • Mount the unit so that the mounting angle is 30° or less. Control input White/Black FRONT • L + White Gray/Black FRONT • R + Gray N O Gray/Black Gray N O KDC-D300 R Speaker input cable(Accessory4) L 2CAUTION If the speaker input cable is not connected, or connected wrongly, the spectrum analyser will not be displayed. - 10 -