Kenwood KDC-D300 Instruction Manual - Page 6

English Operations Buttons and Display Release button CD PLAYER KDC-D300 INTEGRATED QUAD 1 BIT D/A CONVERTER MENU DISP DIGITAL OPTIMUM SERVO CONTROL 60 120 250 380 500 750 1k 2k 4k DPAC 11BAND11BAND 8k 16k SPECTRUM ANALYZER DISP button Setting of the O-N switch will be required depending on the Centre unit that is to be connected. (See Page 10.) The operations you perform and the resultant operation of the unit will differ depending on the setting of the O-N switch. Please see the appropriate description of operations for the "O" or "N" switch setting. Playing CDs NOTE The various CD operations are performed with the Centre unit. For information about the operation method, please see the Centre unit instruction manual. 2CAUTION • When inserting a CD, make sure the CD has been completely drawn in before pushing back the faceplate. Failing to do so might scratch the CD. • Do not attempt to insert a CD into the slot if another one is already there. • The unit can only play 12 cm (5 in). CDs. If you insert a 8 cm (3 in). CD, it will get stuck inside and can cause the unit to malfunction. Operation for "N" Setting: 1 A press of the release button causes the faceplate to drop to the front, thereby exposing the CD slot. 2 Holding the CD with the labeled side facing up, insert it in the slot. The CD will start playing. 3 Push back on the right side of the faceplate with your hand until it locks. NOTE • Select "CD2" when this unit is connected to tha CD receiver. • Selection of the "CD" mode when a CD has not been loaded results in the display of "EJECT" or "E-01". • For centre units brought on to the market from 1999 onwards, it is not possible to switch to the CD mode unless a CD has already been inserted. Operation for "O" Setting: 1 A press of the release button causes the faceplate to drop to the front, thereby exposing the CD slot. 2 Holding the CD with the labeled side facing up, insert it in the slot. 3 Set the source mode of the centre unit to the "DISC" mode. CD play will begin. NOTE • Depending on the unit that is connected, "DISC-1" or "DISC-2" will be displayed. • Selection of the "DISC" mode when a CD has not been loaded results in the display of "EJECT" or "E-01". • Setting the source mode of the Centre unit to a setting other than disc changer mode will cause the indicators and button illumination of this unit to be switched off, but the CD loading/eject operation will still be possible. • To allow the Centre unit to recognize this unit as a disc changer, disc switching operations such as the following are not permitted: disc search and disc repeat, disc name preset play, etc. -6-