Kenwood KDC-X993 Instruction Manual - Page 54

Troubleshooting Guide

Get Kenwood KDC-X993 - eXcelon Radio / CD PDF manuals and user guides
UPC - 019048183248
View all Kenwood KDC-X993 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 54 highlights

Troubleshooting Guide Some functions of this unit may be disabled by some settings made on this unit. ! • Cannot set up the subwoofer. • No output from the subwoofer. • Cannot set up the subwoofer position of Manual position setting. ▲ • of (page 4) is not set to On. • The Dual zone function is enabled. ☞ (page 28) ! • Cannot set up the subwoofer phase. ▲ The Low Pass Filter is set to Through. ☞

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
54
|
KDC-X993/ KDC-HD942U/ KDC-X693/ KDC-MP642U
Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
!
•
Cannot set up the subwoofer.
•
No output from the subwoofer.
•
Cannot set up the subwoofer position of Manual
position setting.
▲
•
<Subwoofer output> of <Basic Operation> (page 4)
is not set to On.
•
The Dual zone function is enabled.
☞
<Audio
Setup> (page 28)
!
•
Cannot set up the subwoofer phase.
▲
The Low Pass Filter is set to Through.
☞
<X’Over
setting> (page 30)
!
•
Cannot select the output destination of the
subsource in the Dual zone.
•
Cannot adjust the volume of the rear speakers.
▲
The Dual zone function is disabled.
☞
<Audio
Setup> (page 28)
!
•
Cannot register a security code.
•
Cannot set up Display.
▲
<Demonstration mode Setting> (page 27) is not
turned off.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
?
The Touch Sensor Tone does not sound.
✔
The preout jack is being used.
☞
The Touch Sensor Tone cannot be output from
the preout jack.
Tuner source
?
Radio reception is poor.
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
Disc source
?
The specified disc does not play, but another one
plays instead.
✔
The specified CD is quite dirty.
☞
Clean the CD, referring to the CD cleaning of the
section on <Handling CDs> (page 3).
✔
The disc is loaded in a different slot from that
specified.
☞
Eject the disc magazine and check the number
for the specified disc.
✔
The disc is severely scratched.
☞
Try another disc instead.
Audio file source
?
The sound skips when an Audio file is being
played.
✔
The media is scratched or dirty.
☞
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 3).
✔
The recording condition is bad.
☞
Record the media again or use another media.