Kenwood KDCMP332 Instruction Manual - Page 10
Audio Setup, Speaker Setting
View all Kenwood KDCMP332 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
General features Audio Setup Setting the Sound system, such as Cross over Network. 1 Select the source to adjust Press the [SRC] button. 2 Enter Audio Setup mode Press the [VOL] knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Setup the Audio item Turn the [VOL] knob. Adjustment Item Display Front High Pass Filter*2 "HPF" Rear High Pass Filter*2 "HPR" Low Pass Filter*1,2 "LPF" Subwoofer Phase*1,2,3 "PHAS" Volume offset "V-OFF" Loudness "LOUD" Range Through/80/100/120/150/ 180 Hz Through/80/100/120/150/ 180 Hz 60/80/120/Through Hz Reverse (180°) / Normal (0°) -8 - ±0 OFF/ON Speaker Setting Fine-tuning so that the System Q value is optimal when setting the speaker type. 1 Enter Standby Press the [SRC] button. Select the "STANDBY" display. 2 Enter Speaker Setting mode Press the [VOL] knob. 3 Select the Speaker type Turn the [VOL] knob. Each time you turn the knob, the setting alternates between the settings shown in the table below. Speaker type OFF For 5 & 4 in. speaker For 6 & 6x9 in. speaker For the OEM speaker Display "SP OFF" "SP 5/4" "SP 6*9/6" "SP OEM" 4 Exit Speaker Setting mode Press the [VOL] knob. • Volume offset: Sets each source's volume as a difference from the basic volume. • Loudness: Compensates for low and high tones during low volume. • *1 You can control this item when (page 11) is set to "SW ON". • *2 Function of the KDC-MP4032. • *3 You can control this item when Low Pass Filter is not set to Through. 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. 10 | English