Kenwood KMR-D375BT Instruction Manual - Page 43

INSTALLATION/CONNECTION Part list for installation (A) Faceplate (×1) (B) Trim plate (×1) Installing the unit (in-dash mounting) Do the required wiring. (Page 40) (C) Mounting sleeve (×1) (D) Wiring harness (×1) (E) Extraction key (×2) (F) Screws* M5 × 7 mm (×4) M5 × 6 mm (×4) M4 × 8 mm (×1) * Supplied for / / . Basic procedure 1 Remove the key from the ignition switch, then disconnect the terminal of the car battery. 2 Connect the wires properly. See "Wiring connection" on page 40. 3 Install the unit to your car. See "Installing the unit (in-dash mounting)". 4 Connect the terminal of the car battery. 5 Press BSRC to turn on the power. 6 Detach the faceplate and reset the unit within 5 seconds. (Page 3) Hook on the top side Orientate the trim plate as illustrated before fitting. Dashboard of your car Bend the appropriate tabs to hold the sleeve firmly in place. Installing the unit (without mounting sleeve) 1 Remove the mounting sleeve and trim plate from the unit. 2 Align the holes in the unit (on both sides) with the vehicle mounting bracket and secure the unit with screws (supplied/commercially available). Removing the unit 1 Detach the faceplate. 2 Fit the catch pin on the extraction keys into the holes on both sides of the trim plate, then pull it out. 3 Insert the extraction keys deeply into the slots on each side, then follow the arrows as shown on the illustration. Use only the specified screws. Using wrong screws might damage the unit. ENGLISH 39