Kenwood KRF-V5020 User Manual - Page 13

Setting up the system Preparing the remote control (RC-R0710) Loading the batteries 1 Remove the cover. 2 Insert the batteries. Preparing for surround sound KRF-V7020/V6020/V5020 (En/T) Speaker settings 13 To enable you to obtain optimum enjoyment from the receiver's listening modes, make sure to complete the speaker settings as described below. SETUP MULTI CONTROL Preparations 3 Close the cover. • Insert two AA-size (R6) batteries as indicated by the polarity markings. Operation When the STANDBY indicator is lit, the power turns ON when you press the POWER key on the remote control. When the power comes ON, press the key you want to operate. Operating range (Approx.) Remote sensor 6 m 30˚ 30˚ Model: RC-R0710 Infrared ray system • When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys. Notes 1. The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks. 2. When the remote-controllable distance gets shorter than before, replace both batteries with new ones. 3. Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction. In such a case, change the location of the system installation to prevent malfunction. VIDEO TUNING/SKIP MULTI CONTROL SETUP SETUP RC-R0508 1 Turn on the receiver. RC-R0710 $ 2 Select a speaker system. 1 Press the SETUP key to make the subwoofer setting indication (SUBW) appear. sUBW Y Es SP A L R SW STEREO 2 Use the MULTI CONTROL (TUNING/SKIP) to select the appropriate subwoofer setting. 1 SUBW YES: A subwoofer is connected to the receiver. 2 SUBW NO: No subwoofer is connected to the receiver. 3 Press the SETUP key to accept the setting. • The center speaker setting indication (CNTR) appears. CNTR N ML SP A L R SW STEREO 4 Use the MULTI CONTROL (TUNING/SKIP) to select the appropriate center speaker setting. 1 CNTR NML (normal): 2 CNTR LRG (large): 3 CNTR NO: An average size center speaker is connected to the receiver. A large center speaker is connected to the receiver. No center speaker is connected to the receiver. 5 Press the SETUP key to accept the setting. • The surround speaker setting indication (SURR) appears. 6 Use the MULTI CONTROL (TUNING/SKIP) to select the appropriate surround speaker setting. 1 SURR YES: Surround speakers are connected to the receiver. 2 SURR NO: No surround speakers are connected to the receiver. 7 Press the SETUP key to accept the setting. • The receiver enters the speaker volume level adjustment mode. • In steps 3 and 4, indications appear only for the selected channels of the speakers that require adjusting. Continued to next page