Kenwood KTC-HR200 Instruction Manual - Page 15
IQ6rr - how to install
UPC - 019048178886
View all Kenwood KTC-HR200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Insta Ilation Connecting Wires to Terminals ~L.~ -----,IControl Unit (5L connector) • Control Unit '-~t---~ (KAB connector) .- ======~r"~ ~ Accessorv(2) O/'f\N3~ ~ ~ • The unit can only be connected to a control unit with either SL or KAB connector. Antenna Cable (AccessoryG)) C~~P:CI I] To FM/AM antenna ' KTC-HR200 SELECT SWITCH Set "SELECT SWITCH" 1 depending on a IQ6rr connector type of a control unit to be used. When connecting to the control unit with 5L connector, set this switch down, SL and when KAB connector set the switch up (ON). ~ ~ Keep "SELECT SWITCH" 2 down. If you set the switch up (ON), the unit does not operate normally. KAB Connector units KVT-512, DDXS12, DNXS 120, DNXS12EX, DDX812, DDX712, DNX8120, DNX7120 (As of April, 2008) Installation Remove the backing from the velcro strips (Accessory@) and attach it to the bottom of the unit. Install the switching unit on the carpet. Lt • Please do not install the unit near the dashboard, the rear tray, or other important components. Doing so could lead to injury or accident should the unit come off due to a shock and strike a person or an important component. @2 • Do not stick the velcro tape over the serial number. English I En-1S