Kenwood KTS300MR Instruction Manual - Page 31
Installation - installation manual
UPC - 019048158987
View all Kenwood KTS300MR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Installation Installation 1 Confirm the mounting position. 2 Place template (accessory 8) on Mounting Surface. Mark each location to be drilled. 3 Cut the mounting surface. Remove the template (accessory 8). Mounting Surface 5 Attach the Foam Tape (accessory 7). 6 Attach the drip shield (accessory 6). Accessory7 Accessory6 Template (Accessory8) • When making a hole in the vessel, check that there is nothing hazardous on the opposite side such as a pipe , or wiring harness, and be careful not to cause scratches or other damage. • Machine the surface to specified dimensions. Otherwise, the unit might not be secured fully, or damage might result. NN w NN w NN w NN w NN w NN w NN w NN w 4 Attach the packing (accessory 2). Accessory2 */4*%& Accessory2 7 Secure the main body with screws (accessory 5) and brackets (accessory 4). Orient the brackets with the "INSIDE" arrows facing inward. 8 The screws (accessory 5) tightening torque is thing of 0.74 N•m ± 0.24 N•m (7.5 kgf-cm ± 2.5 kgf-cm) or less. Accessory4 Mounting */4*%& Surface Screw (M4 × 50mm) Washer (Accessory5) 9 Attach the side cover (accessory 3). Accessory3 Remote controller Refer to the instruction manual of Remote controller. English | 31