Kenwood TK-385 Operation Manual - Page 23

Scanning

Get Kenwood TK-385 PDF manuals and user guides View all Kenwood TK-385 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Scanning Press the A key to turn Scan ON (or OFF). While scanning, the SCN indicator and "-SCAN-" appear on the display. When a call is received, scanning stops and the channel number appears. Press the PTT switch and speak into the microphone to respond to the call. The transceiver will continue scanning after an adjustable time delay if the PTT switch is released and no further signal is received. Only channels added to the scanning sequence will be scanned. Channels which are added to the scanning sequence all have an add indicator ( ▼ ) in the left-most segment of the main display. To add a channel to the scanning sequence, select the desired channel, then press the B key. • ▼ appears on the display. To remove a channel from the scanning sequence, select the desired channel, then press the B key. • ▼ no longer appears on the display. Lamp To light up the display and keypad, press the D key. The lamp will remain ON for approximately 5 seconds. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
19
Scanning
Press the
A
key to turn Scan ON (or OFF).
While scanning, the
SCN
indicator and “-SCAN-” appear
on the display.
When a call is received, scanning stops and the channel
number appears.
Press the
PTT
switch and speak into
the microphone to respond to the call.
The transceiver
will continue scanning after an adjustable time delay if
the
PTT
switch is released and no further signal is
received.
Only channels added to the scanning sequence will be
scanned.
Channels which are added to the scanning
sequence all have an add indicator (
▼
) in the left-most
segment of the main display.
To add a channel to the scanning sequence, select the
desired channel, then press the
B
key.
•
▼
appears on the display.
To remove a channel from the scanning sequence,
select the desired channel, then press the
B
key.
•
▼
no longer appears on the display.
Lamp
To light up the display and keypad, press the
D
key.
The lamp will remain ON for approximately 5 seconds.