Kenwood TK-385 Operation Manual - Page 6

Preparation

Get Kenwood TK-385 PDF manuals and user guides View all Kenwood TK-385 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

PREPARATION Installing/ Removing the (Optional) NiCd Battery Pack ◆ DO NOT RECHARGE THE BATTERY PACK IF IT IS ALREADY FULLY CHARGED. DOING SO MAY CAUSE THE LIFE OF THE BATTERY PACK TO SHORTEN OR THE BATTERY PACK MAY BE DAMAGED. ◆ AFTER RECHARGING THE BATTERY PACK, DISCONNECT IT FROM THE CHARGER. IF THE CHARGER POWER IS RESET (TURNED ON AFTER BEING TURNED OFF), RECHARGING WILL START AGAIN AND THE BATTERY PACK WILL BECOME OVERCHARGED. ◆ DO NOT SHORT THE BATTERY TERMINALS OR DISPOSE OF THE BATTERY BY FIRE. ◆ NEVER ATTEMPT TO REMOVE THE CASING FROM THE BATTERY PACK. 1 Match the four grooves of the battery pack with the corresponding guides on the back of the transceiver. 2 Slide the battery pack along the back of the transceiver until the release latch on the base of the transceiver locks. 3 To remove the battery pack, pull back on the release latch and slide the pack away from the transceiver. 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
2
PREPARATION
1
Match the four grooves of
the battery pack with the
corresponding guides on
the back of the transceiver.
2
Slide the battery pack along
the back of the transceiver
until the release latch on
the base of the transceiver
locks.
3
To remove the battery pack,
pull back on the release
latch and slide the pack
away from the transceiver.
Installing/ Removing the (Optional) NiCd Battery Pack
◆
DO NOT RECHARGE THE BATTERY PACK IF IT IS ALREADY
FULLY CHARGED.
DOING SO MAY CAUSE THE LIFE OF THE
BATTERY PACK TO SHORTEN OR THE BATTERY PACK MAY
BE DAMAGED.
◆
AFTER RECHARGING THE BATTERY PACK, DISCONNECT IT
FROM THE CHARGER.
IF THE CHARGER POWER IS RESET
(TURNED ON AFTER BEING TURNED OFF), RECHARGING
WILL START AGAIN AND THE BATTERY PACK WILL BECOME
OVERCHARGED.
◆
DO NOT SHORT THE BATTERY TERMINALS OR DISPOSE
OF THE BATTERY BY FIRE.
◆
NEVER ATTEMPT TO REMOVE THE CASING FROM THE
BATTERY PACK.