Kenwood VR-50RS User Manual - Page 18
Normal playback
View all Kenwood VR-50RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Preparing for surround sound 3 Use the MULTI CONTROL knob or MULTI CONTROL %/fi keys to select the distance to the front speakers. Indication in feet Indication in meters • The allowable setting range is 1 to 30 feet (0.3m to 9.0m), adjustable in 1 foot (0.3m) increments. 4 Press the SETUP key to accept the settings. 5 Repeat steps 3 and 4 to input the distance for each of the speakers. 6Adjust the LFE (Low Frequency Effects) level. 1 Select the LFE LEVEL from the set up displays and press the SETUP key again. 2 Use the MULTI CONTROL knob or MULTI CONTROL %/fi keys to adjust the LFE LEVEL. • The LFE LEVEL can be adjusted from 0dB to -10dB in 1dB step decrements. 3 Press the SETUP key to accept the setting. 4 Setup is complete when the EXIT indication appears. Normal playback Preparing for playback Some preparatory steps are needed before starting playback. Turning on this model 1 Turn on the power to the related components. 2 Turn on the power to this model by pressing POWER ON/ STANDBY key. Selecting the input mode If you have selected a component connected to the CD/DVD, VIDEO2 or DVD jacks, make sure that the input mode setting is correct for the type of audio signal to be used. 8 • The speakers you have selected should appear on the display. Confirm that all the speakers have been correctly selected. 5 Press the SETUP key to exit the SETUP mode. Input level adjustment (analog sources only) If the input level of an analog source signal is too high, the CLIP indicator will blink to indicate the source signal. Adjust the input level. 1 Use the INPUT SELECTOR knob to select the source of which the input level you want to adjust. • You can store a separate input level for each input source. 2 Press the SOUND key repeatedly until the "INPUT" indication appears. 3 Use the MULTI CONTROL knob or MULTI CONTROL %/fi keys to adjust the input level. Selecting MD/TAPE Select the source name corresponding to the component connected to the MD/TAPE jacks. The initial factory setting is "TAPE". To change the source to "MD", follow the steps below: 1 Use the INPUT SELECTOR knob to select "TAPE". 2 Hold down the AUTO/MONO key for more than 2 seconds. • The source indication changes to "MD". • To return to the original indication, repeat procedure 2. Setting the speaker status The speaker indicator lights up. Press the SPEAKERS ON/OFF key to switch the speaker on or off. • The input level may be adjusted to any one of three settings: 0dB, -3dB, and -6dB. (The initial setting is 0dB.) 4 Press the SOUND key again to return to the input indication. 18 EN