KitchenAid KDRP463LSS Installation Instructions - Page 7
KitchenAid KDRP463LSS - 36" Pro-Style Dual Fuel Range Manual
View all KitchenAid KDRP463LSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Remove cardboard or hardboard from under range. 8. use pipe-joint compound regulator flexible connector burner cap manual gas shutoff valve ignitor electrode burner base 3 front screws (4 rear screws required but not shown) 1/2" flare union 1/2" to 3/4" gas pipe adapter a 1/2" male pipe thread is needed for connection to pressure regulator female pipe threads gas tube opening attaching the backguard Make gas connection. Assemble flexible connector from gas supply pipe to pressure regulator located in the middle front of the range. Apply pipe-joint compound made for use with L.P. gas to the smaller thread ends of the flexible connector adapters. Attach one adapter to the pressure regulator elbow and the other adapter to the gas shutoff valve. Tighten both adapters. 11. Put a burner cap on each burner base. Place burner grates over burner bases and caps. If your model has only surface burners (no grille or griddle), go to "Check the operation of the surface burners, grille and griddle" on Page 9. If your model was shipped with a grille or griddle, go to "Installing the grille or griddle" on Page 8 to complete the installation. 14. shutoff valve "open" position gas supply line attaching the island trim center hole not used to range Attach the backguard or island trim as required for your installation. Attachment screws are in the literature package. 9. Open manual shutoff valve in gas supply line. Wait a few minutes for gas to move through the line. 12. 13. Turn on power supply. "PF" should appear in the clock display. (Refer to your Use and Care Guide for instructions on using the electronic control.) 15. Slide range completely back so anti-tip bracket is over rear brace of range. 10. Leak testing of the appliance shall be conducted according to the following instructions: Use a brush and liquid detergent to test all gas connections for leaks. Bubbles around connections will indicate a leak. If a leak appears, shut off gas valve controls and adjust connections. Then check connections again. Clean all detergent solution from range. 7