KitchenAid KDRS463VBK Installation Instructions - Page 15
Install Water Filtration System, on some models
![]() |
View all KitchenAid KDRS463VBK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
4-wire connection: power supply cord Use this method for: ■■ New branch-circuit installations (1996 NEC) ■■ Mobile homes ■■ Recreational vehicles ■■ In an area where local codes prohibit grounding through the neutral 1. Remove the ground-link screw from the range frame. Save the ground-link screw. Bend the ground link away from the range so that it does not contact the range. B A A. Ground-link screw B. Ground link bent away from range 2. Connect the green ground wire from the power supply cord to the range using the ground-link screw. The ground wire must be attached first and must not contact any other terminal. 3. Use a ¼" nut driver to remove the hex washer head screws from the terminal blocks. 4. Connect the neutral (center) wire to the center terminal connector using one of the hex washer head screws. Securely tighten screw for proper electrical connection. E D F C B G H A I A. Line 1 B. Green ground wire C. Ground-link screw D. Hex washer head screw E. Silver-colored terminal block screw F. Ground link G. Neutral (center) wire H. Line 2 I. UL listed strain relief and 40- or 50-amp range power supply cord 5. Connect the other 2 wires (lines 1 and 2) to the outer aluminum terminal blocks. 6. Securely tighten screws for proper electrical connection. 7. Tighten strain relief screws. 8. Replace terminal block cover. 3-wire connection: power supply cord Use this method only if local codes permit connecting cabinet-ground conductor to neutral wire of power supply cord. 1. Use a ¼" nut driver to remove the hex washer head screws from the aluminum terminal blocks. 2. Connect the neutral (center) wire to the center terminal connector using one of the hex washer head screws. Securely tighten screw for proper electrical connection. D C E B F A G A. Line 1 B. Ground link C. Hex washer head screw D. Silver-colored terminal block screw E. Neutral (center) wire F. Line 2 G. UL listed strain relief and 40- or 50-amp range power supply cord 3. Connect the other 2 wires (lines 1 and 2) to the outer terminal screws on the terminal block. 4. Tighten strain relief screws. 5. Replace terminal block cover. Install Water Filtration System (on some models) Install Model W10049700 Water Filter 1. Install the water filter near the cold water supply pipe under the kitchen sink to filter the cold water. IMPORTANT: Be sure to allow a minimum clearance of 1½" (3.8 cm) under the filter system for removing the filter cartridge. Make sure that the water filter assembly is installed in the upright position. Typical Installation Configuration NOTE: For unique installations, contact a licensed plumber. In Massachusetts, a licensed plumber is required and the Commonwealth of Massachusetts Plumbing Code 248-CMR will be adhered to. Water supply line to oven Cold water supply Hot Cold Filter Assembly Water supply line to cold water supply 2. Attach the supplied water filter mounting ring and screw at the recommended location. 15
![](/manual_guide/products/kitchenaid-kdrs463vbk-installation-instructions-d4ab33e/15.png)