KitchenAid KECD866RWW Installation Instructions - Page 3

Product Dimensions 21-5/16" (54.1 cm) depth 30-3/8" (77.1 cm) - 30" (76.2 cm) models 36-3/8" (92.3 cm) - 36" (91.4 cm) models width Cutout Dimensions 29-1/2" (74.9 cm) - 30" (76.2 cm) model 35-1/2" (90.2 cm) - 36" (91.4 cm) model cutout width 21" (53.3 cm) cutout depth 2-15/16" (74.6 mm) burner box depth 15-5/8" (39.6 cm) blower housing depth 3-ft. (91.4 cm) long power supply cable factory installed. Clearance Dimensions 30" (76.2 cm) min - 30" (76.2 cm) model 36" (91.4 cm) min - 36" (91.4 cm) model when higher than 18" (45.7 cm) Select required duct cutout (see Page 4 for exhaust duct cutout location). 2" (5.1 cm) minimum space to front edge of countertop Countertop must be supported within 3" (7.6 cm) of cutout. countertop Install rear wall junction box in shaded area. Darker shaded area is preferred. 5" (12.7 cm) 18" (45.7 cm) floor 11" (27.9 cm) 8" (20.3 cm) See Note ** for minimum clearances Minimum distance to nearest combustible vertical surface extending 18" (45.7 cm) above cooktop 1" (25.4 mm) Do Not seal cooktop to countertop. 21" (53.3 cm) opening depth 29-1/2" (74.9 cm) - 30" (76.2 cm) model 35-1/2" (90.2 cm) - 36" (91.4 cm) model cutout width Side clearance - 6" (15.2 cm) minimum clearance between side of cooktop and side wall is recommended for maximum ventilation performance. Rear clearance - 3/4" (19.1 mm) clearance between rear edge of cooktop and rear wall is recommended. Motor/blower clearance - 2" (51 mm) minimum clearance between motor and cabinet is required for proper cooling. 6" (15.2 cm) clearance is recommended for servicing access. ** Note: 24" (61 cm) minimum when bottom of wood or metal cabinet is protected by not less than 1/4" (6.4 mm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) minimum clearance between the top of the cooking platform and bottom of unprotected wood or sheet metal. Minimum base cabinet dimensions - 30" (76.2 cm) base cabinet width 24" (61 cm) base cabinet depth 25" (63.5 cm) countertop depth Countertop opening dimensions that are shown must be used. Given dimensions are minimum clearances and provide required 0" (0 cm) clearance. New installations - Follow minimum dimensions given. Replacement installation - Be sure that front edge of cooktop is at least 1-1/2" (38.1 mm) back from front edge of countertop. If cabinet has drawers, drawers will need to be removed and drawer fronts installed on front of cabinet. Cutout preparation: Decorative laminate - Chamfer all exposed edges to prevent chipping laminate. Cut radius corners and file to smooth edges and to prevent cracking. 3