KitchenAid KGCU463VSS Installation Guide - Page 11

Install Grill Grease Trays (on grill models) 1. Remove flame spreader. Pull forward slightly on the flame spreader to release the tabs from the rear slots and lift out. 6. Insert the small grease tray all the way under the front of the grill basin and hook it into the slots. When the 2 grease trays are installed properly, the small B grease tray will hook over the large grease tray. A B C A A. Grill front B. Rear tabs and slots 2. Cut and remove tie strap from rear of burner assembly. A D A. Large grease tray B. Grease tray connection C. Small grease tray D. Slots 7. Insert the orifice tube on the front of the burner assembly into the opening at the front of the grill basin and set burner assembly into place. A. Tie strap 3. Lift burner assembly up and out to remove. 4. Slide drip tray into opening on the right front side of the grill basin. There are guides to assure correct placement of the drip tray. A A A. Front opening 8. Insert front tabs of the flame spreader into slots at the front of the grill basin, then the rear tabs into the rear slots. B A. Drip tray 5. Insert the large grease tray all the way under the back edge of the grill basin and hook it into the slots. A A. Front tabs and slots B. Rear tabs and slots 9. Check the surface burner and grill flames. Refer to "Electronic Ignition System" in the "Complete Installation" section. 10. Place the wave tray on top of the flame spreader. B A A. Large grease tray B. Slots 11. Place the grill grate into position. 11