KitchenAid KGSS907SBL Installation Instructions - Page 15
Replace Oven Racks and Warming or, Storage Drawer, Complete Installation
UPC - 883049027517
View all KitchenAid KGSS907SBL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Check Operation of Oven Broil Burner 1. Close the oven door. 2. Press the BROIL pad. "FULL BROIL" and broil temperature will appear in the temperature display. 3. Press the START pad. "ON" indicator will light. The oven burner should light within 8 seconds. Under certain conditions it may take the burner up to 50 to 60 seconds to light. On some models, an electric halo element also turns on. Replace Oven Racks and Warming or Storage Drawer Replace oven racks in oven cavity. Replace warming drawer or storage drawer. To Replace Warming Drawer: 1. Align the drawer glides with the receiving guides. A B A. Gas burner B. Electric halo element NOTE: Oven door must be shut for broil burner to operate. Adjust Oven Broil Burner Flame (if needed) Look through oven window to check broil burner for proper flame. This flame should have a ½" (1.3 cm) long inner cone of bluish-green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur. A B A. Locking screw B. Air shutter If flame needs to be adjusted: 1. Use a flat-blade screwdriver to loosen the locking screw on the air shutter located at the rear of the broil burner. 2. Adjust the air shutter as need. 3. Tighten lock screw. 2. Push drawer in all the way. Gently open and close the drawer to ensure it is seated properly on the slides. To Replace Storage Drawer: 1. Fit the ends of the drawer rails into the guides in the cavity. 2. Slide the drawer closed. Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Check that the range is level. See "Level Range." 5. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, see the "Range Care" section of the Use and Care Guide or User Instructions. 6. Read the Use and Care Guide or User Instructions. 7. Turn on surface burners and oven. See the Use and Care Guide or User Instructions for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight, or circuit breaker has not tripped. ■ Range is plugged into a grounded 3 prong outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in the Use and Care Guide or User Instructions. 8. When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shutoff valve is open. ■ If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above. ■ If the gas supply line shutoff valve is open, press the CANCEL button on the oven control panel and contact a qualified technician. If you need Assistance or Service: Please reference the "Assistance or Service" section of the Use and Care Guide or the cover of the User Instructions, or contact the dealer from whom you purchased your range. 15