Kyocera ECOSYS P6130cdn PRESCRIBE Commands Command Reference Manual Rev 5.1 - Page 218
STAK 3; CMNT Stack to the finisher, PNCH 1, JOBS 1
View all Kyocera ECOSYS P6130cdn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
PRESCRIBE Command Reference File The mode parameters of 51, 52, 61, 62, 71, and 72 are valid for some copier models only. These parameters allow to position the holes in either of the left, right, and top sides of the page by logically aligning the page in reference to the punched holes. Note that the mode parameter is valid for a finisher with the dual mode punching system, such as the DF-71, only. It becomes invalid if it is specified in a finisher with the standard punch unit.With a finisher with the standard punch unit only (e.g. the DF-75), the number of punched holes is uniquely determined according to the country of destination and paper size. Like stapling and other finishing operations, punching is done per one job at a time. Therefore, this command is invalid unless it is used in combination with JOBS. See Page 140. The option finisher is not switched automatically by this command to perform punching. Therefore, it is necessary in advance to specify the option finisher as the output destination using the STAK 3; command. The following example is for European countries. !R! STAK 3; CMNT Stack to the finisher; PNCH 1; JOBS 1, 1, 2, 0, 0; TEXT 'This page is punched with two holes.'; JOBT; EXIT; 208