Kyocera ECOSYS P6130cdn PRESCRIBE Commands Command Reference Manual Rev 5.1 - Page 65
Clpr
View all Kyocera ECOSYS P6130cdn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
CLPR CLPR - CLiP Rectangular area Format CLPR [x1, y1, x2, y2]; Parameters x1: x coordinate of the top-left corner of the rectangle y1: y coordinate of the top-left corner of the rectangle x2: x coordinate of the bottom-right corner of the rectangle y2: y coordinate of the bottom-right corner of the rectangle Function The CLPR command describes a rectangular path which intersects the inside of the texts, current path, or raster graphics objects. The clipping rectangle does not clip those graphics segments drawn in the standard mode graphics. Any painting operations outside the specified rectangle is erased and those segments within it are painted on the page. The coordinates are measured from the top and left edge limits in the units designated by the UNIT command. If the parameters are omitted, the rectangle is equal to the size of the current page size. If an attempt is made to position the top-left corner to the right of the bottom-left corner [greater values for (x1, y1) than for (x2, y2)], the printing system exchanges the coordinate values with each other. The printing system resets the size of the rectangular clipping path to be equal to the maximum printable area of the current page size when a PSRC, RES, SPO, or SPSZ (Set Page SiZe) command is encountered. 55