Kyocera FS 1010 FS-1010 Operation Guide Rev-1.2 - Page 74
B.2 USB Interface, B.2.1 Specifications, B.2.2 Interface Signals, B.2.1
View all Kyocera FS 1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
USB Interface B.2 USB Interface This printer supports the Full-Speed USB (Universal Serial Bus) 2.0 standards. USB interface specifications and interface signals are as follows. B.2.1 Specifications Basic specification Complies with the Full-Speed USB 2.0 standards. Connectors Printer: B-type receptacle (female) with upstream port Cable: B-type plug (male) Cable Use shielded cable that complies with the Full-Speed USB 2.0 standards and not longer than 5 meters (16 feet). Transfer Mode Full speed (max. 12 Mbps) Power Control Self-power device B.2.2 Interface Signals Pin 1 2 3 4 Shell Table B.2 USB Connection Pin Assignment Signal Vbus DD+ GND Description Power supply (+5 V) Data transmission Data transmission Signal ground Shield B-6
USB Interface
B-6
B.2
USB Interface
This printer supports the Full-Speed USB (Universal Serial Bus) 2.0
standards. USB interface specifications and interface signals are as
follows.
B.2.1
Specifications
Basic specification
Complies with the Full-Speed USB 2.0 standards.
Connectors
Printer: B-type receptacle (female) with upstream port
Cable: B-type plug (male)
Cable
Use shielded cable that complies with the Full-Speed USB 2.0 standards
and not longer than 5 meters (16 feet).
Transfer Mode
Full speed (max. 12 Mbps)
Power Control
Self-power device
B.2.2
Interface Signals
Table B.2 USB Connection Pin Assignment
Pin
Signal
Description
1
Vbus
Power supply (+5 V)
2
D-
Data transmission
3
D+
Data transmission
4
GND
Signal ground
Shell
Shield