Kyocera FS-1300DN Service Manual - Page 23
Installing the memory card (optional), R! RWER F, A; EXIT
View all Kyocera FS-1300DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
1-2-4 Installing the memory card (optional) 1. Turn off printer power switch. Caution: Do not insert or remove memory card while printer power is on. Doing so may cause damage to the printer and the memory card. 2. Open the rear cover. 2H5/2HS-1 3. Remove two screws and then remove the optional interface slot cover. 4. Insert the memory card into the memory card slot. Push it in all the way. 5. Secure the optional interface slot cover by using two screws. 6. Format the memory card before use. To format the memory card: Send the following PRESCRIBE command sequence from the PC to the printer. !R! RWER F, A; EXIT; Note: To send a PRESCRIBE command sequence to the printer, use COMMAND CENTER (the printer's embedded web) while the printer is connected to the PC via its network interface. Rear cover Figure 1-2-6 Memory card slot Memory card Screw Screw Optional interface slot cover Figure 1-2-7 1-2-5