LG CBGS3628S INSTALLATION - Page 6

en-us_main.book.book Page 6 Friday, November 4, 2022 8:08 AM 6 INSTALLATION INSTALLATION Before Installing Before You Begin Read these instructions completely and carefully. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For assistance or additional information, consult a qualified installer, service agency, manufacturer (dealer) or your gas supplier. Installation of this cooktop must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or, in Canada, the Natural Gas and Propane Installation Code, CSA B149.1. As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find these precautions in the IMPORTANT SAFETY INSTRUCTIONS chapter. Read them carefully. IMPORTANT: • Save these instructions for the local electrical inspector's use. • Observe all governing codes and ordinances. NOTE • Installer: Leave these instructions with the appliance after installation is completed. • Consumer: Keep the owner's manual and installation manual for future reference. • This appliance must be properly grounded. • The electrical diagram is in an envelope attached to the back of the cooktop. • Skill level - Installation of this appliance requires basic mechanical skills. • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. • Remove all tape and packaging. • Make sure the burners are properly seated and level. • Take the accessory pack off of the cooktop. • Check to be sure that no cooktop parts have come loose during shipping. In the Commonwealth of Massachusetts • This product must be installed by a licensed plumber or gas fitter. • When using ball type gas shut-off valves, they must be the T-handle type. • A flexible gas connector, when used, must not exceed 3 feet in length. Tools and Materials Tools You Will Need a Phillips Screwdriver b Flat-blade Screwdriver c Open-end or Adjustable Wrench d Pencil and Ruler e Pipe Wrench (2 ea) (one for support) Materials You May Need a Joint Sealant b Pipe Fittings c Shut Off Valve d Flexible Connector • Gas line shut-off valve