LG DLE2140W Owner's Manual - Page 34
LG DLE2140W Manual
UPC - 048231011402
View all LG DLE2140W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
BEFORE CALLING FOR SERvICE (cont.) Problem Drying time is not consistent Possible Causes • Heat settings, load size, or dampness of clothing is not consistent. Solutions • The drying time for a load will vary depending on the heat setting, the type of heat used (electric, natural, or LP gas), the size of the load, the type of fabrics, the wetness of the clothes, and the condition of the exhaust ducts and lint filter. • Separate heavy items from lightweight items. Larger and heavier items take longer to dry. • Heavy fabrics take longer to dry because they tend to retain more moisture. To help reduce and maintain more consistent drying times for large and heavy fabrics, separate these items into smaller loads of a consistent size. • Use the appropriate control settings for the type of load you are drying. • Make sure the lint filter is cleaned before every load. With some loads that produce high amounts of lint, it may be necessary to clean the filter during the cycle. • Confirm that the exhaust ductwork is properly configured and free of debris, lint, and obstructions. Make sure that outside wall dampers can open properly and are not blocked, jammed, or damaged. • Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the problem is a circuit overload, have it corrected by a qualified electrician. • Divide larger loads into smaller loads for drying. • If you are drying a very small load, add a few extra items to ensure proper tumbling action. • Overdrying a load of laundry can lead to wrinkled clothes. Try a shorter drying time, and remove items while they still retain a slight amount of moisture. • Remove items from the dryer immediately at the end of the cycle. Use the WRINKLE CARE option to continue tumbling clothes at the end of the cycle, for up to 3 hours. • To avoid shrinkage, please carefully follow the fabric care instructions for your garment, because some fabrics will naturally shrink when washed. Other fabrics can be washed but will shrink when dried in a dryer. Use a low or no heat setting. • Check the connection of power cord to the terminal block. Refer to 20-23 pages on this manual. Clothes take too long to dry • Load is not properly sorted. • Large load of heavy fabrics. • Dryer controls are not set properly. • Lint filter needs to be cleaned. • Exhaust ducts blocked, dirty, or duct run is too long. • House fuse is blown, circuit breaker has tripped, or power outage has occurred. • Dryer is overloaded. • Dryer is underloaded. Clothes are wrinkled • Clothes dried too long (overdried). • Clothes left in dryer too long after cycle ends. Clothes are shrinking • Garment care instructions are not being followed. Display shows error codePS • ower cord connection is P incorrect. 34 MFL62512832_EN_100720.indd 34 7/21/10 1:56:07 PM