LG DLG4802W Owner's Manual - Page 26
Installation test Exhaust check
View all LG DLG4802W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
26 INSTALLATION INSTRUCTIONS Installation test (Exhaust check) Once you have completed the installation of the dryer, use this test to make sure the condition of the exhaust system is adequate for proper operation of the dryer. This test should be performed to alert you to any serious problems in the exhaust system of your home. • Your dryer features Flow SenseTM, an innovative sensing system that automatically detects blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use. NOTE The dryer should be cool before starting this test. If the dryer was warmed up during installation, run the AIR DRY cycle for a few minutes to reduce the interior temperature. To activate the Installation test: 1. Press and hold the TEMP. and SIGNAL buttons at the same time. While holding these buttons, press POWER ON/OFF 4. Check the display for results. During the two minute test cycle, monitor the FLOW SENSE display on the control panel. If FLOW SENSE is displayed, when the cycle ends, the exhaust system is adequate. If the exhaust system is severely restricted, the display will show FLOW SENSE. Other problems may also be shown with error codes. Refer to the next page for error code details and solutions. Lighting : Restricted FLOW SENSE indicates that the exhaust system is severely restricted. Have the system checked immediately, as performance will be poor. 5. END of Cycle. At the end of the test cycle, will display. The test cycle will end and the dryer will shut off automatically after a short delay. 2. The dryer will show lnS in the number display to indicate that it is in duct condition testing mode. 3. Press the START/PAUSE button. The dryer will run for approximately 2 minutes to test for blockages or restrictions to air flow in the ductwork.