LG DLG4802W Owner's Manual - Page 34
Before calling for service cont., SPECIFICATIONS, USING SMARTDIAGNOSIS - lp conversion
View all LG DLG4802W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
34 SPECIFICATIONS Before calling for service (cont.) Problem CHECK FILTER light is on during the drying cycle Possible Causes • Lint filter is almost clogged or full. Solutions • Pause the drying cycle and clean the lint filter. FLOW SENSE Light is on during the drying cycle • Ductwork is too long or has too many turns/ restrictions. • Significant blockage of the ductwork due to lint buildup or debris. • The appliance has detected a restriction in the external dryer venting. • Install a shorter or straighter duct run. See the Installation Instructions. • Ductwork should be checked/cleaned soon. Dryer can be used in this condition, but drying times may be longer. • If exhaust restrictions are sensed by the FLOW SENSETM system, the indicator will remain on for two hours after the end of the cycle. Opening the door or pressing the POWER button will turn off the display. SPECIFICATIONS Dryer models Description Electrical Requirements* Gas Requirements* Dimensions Net Weight Drying Capacity - Normal Cycle DLE4801W DLG4802W Dryer Please refer to the rating label regarding detailed information. NG 4-10.5 inches WC LP: 8-13 inches WC (Gas Models only) 26.4"(W) X 29.2" (D) X 43.7" (H), 51" (D with door open) 67.1cm(W) X 74.3cm(D) X 111.0cm(H), 129.5(D with door open) 124.9 lbs (56.6 kg) IEC 7.1 cu.ft. (22.5 lb/10.2 kg) USING SMARTDIAGNOSISTM NOTE - Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax machine, and so has no meaning except to the call center. - SMARTDIAGNOSIS™ cannot be activated if the dryer does not power up. If this happens, then troubleshooting must be done without SMARTDIAGNOSIS™. If you experience problems with your dryer, call 1-800-243-0000 (1-888-542-2623 in Canada). Follow the call center agent's instructions, and do the following steps when requested: 1. Press to turn on the dryer. Do not press any other buttons. 2. When instructed to do so by the call center agent place the mouthpiece of your phone very close to the POWER button. 3. Press and hold Temp.button for three seconds, while holding the phone mouthpiece to the icon or POWER button. 4. Keep the phone in place until the tone transmission has finished. This takes about 17 seconds, and the display will count down the time. • For best results, do not move the phone while the tones are being transmitted and do not touch the control panel with the phone. • If the call center agent is not able to get an accurate recording of the data, you may be asked to try again. • Pressing the POWER button during the transmission will shut off the SMARTDIAGNOSIS™. 5. Once the countdown is over and the tones have stopped, resume your conversation with the call center agent, who will then be able to assist you using the information transmitted for analysis at the call center.