LG DLG5988WM Service Manual - Page 9
wire receptacle
View all LG DLG5988WM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Review the following options to determine the appropriate electrical connection for your home: 4-wire receptacle (NEMA type14-30R) Use the instructions at this section if your home has a 4-wire receptacle (NEMA type 14-30R) and you will be using a UL listed, 120/240 volt minimum, 30 amp, dryer power supply cord. 3-wire receptacle (NEMA type10-30R) Use the instructions at this section if your home has a 3-wire receptacle (NEMA type 10-30R) and you will be using a UL listed, 120/240 volt minimum, 30 amp, dryer power supply cord. 5" (12.7 cm) 31/2" (8.6 cm) 1" (2.5 cm) (12.75c" m) 1" (2.5 cm) 4-wire direct 3V2" (8.9 cm) 4-wire connection : Direct wire Important : use 4-wire connection in the places such as mobile homes and areas where 3-wire connections is not available. Prepare minimum 5ft(1.52m) of length in order for dryer to be replaced. First, peel 5 inch (12.75c" m) of covering mat3e1/2r"ial from end. Make a 5 inch (o12f.7gcrmo)und wire bared.(8A.6fctme)r cutting 11/2 inch (3.8cm) from 3 other wires. peel insulation back 1inch (2.5cm). Make ends of 3 wires a hook shape. 1" (2.5 cm) (12.75c" m) ( Then, put the hooked shape end of the wire under the screw of the terminal block(hooked end facing rightward) and pinch the hook together and screw tightly. If this type is available at your home. you will be connecting to a fused disconnect or circuit breaker box 5" (12.7 cm) 3-wire direct 31/2" (8.6 cm) If this type is available at your home. you will be connecting box to a fused(21d.5"icsmc)onnect or circuit breaker (12.75c" m) 1" (2.5 cm) 3V2" (8.9 cm) 1. Connect neutral wire(white) of power cord to center terminal block screw. 2. Connect red and black wire to the left and right terminal block screws. 3. Connect ground wire(green) of power cord to external ground screw and move neutral ground wire of appliance and connect it to center screw. 4. Make sure that the strain relief screw is tightened. and be sure that all terminal block nuts are on tight and power cord is in right position. d e f c b 9